Daintree GE Current Lumination Tetra Contour 75487 Series Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Luz exterior Daintree GE Current Lumination Tetra Contour 75487 Series. Daintree GE Current Lumination Tetra Contour 75487 Series 7 páginas.

Imprimir página
Lumination
(Tetra
®
Installation
5-8 in. (127-203mm)
5-8 in. (127-203mm)
5-8 in. (127-203mm)
1
Install a mounting clip, using #6
(M2) counter sink screws, every
5–8 inches (127–203mm) on center
until the end of the run is reached.
+ –
+ –
Separate wires
Separate wires
+ –
Separate wires
+
+
–
–
+
–
+
+
+
4
For vertical or near vertical
installations, any cut-end
termination of a Contour piece
shall reside at the top of the
design.
To Tetra Contour
To Tetra Contour
To Tetra Contour
Black or
Black or
Black or
blue (-)
blue (-)
blue (-)
Power
Power
Power
supply
supply
supply
7
Run a wire from the power supply
to a section of Tetra Contour.
Power supply connection must be
completed in an acceptable UL/
NEMA enclosure. Power supply
loading is described in the power
supply installation instructions.
Contour - Series)
®
2
Using the light engine final length,
measure out the necessary length
of Contour light engine. If
required, using a sharp cutting
tool, cut wire loops between
sections or through light engine.
Connect two
Connect two
Connect two
negatives (–)
negatives (–)
negatives (–)
+
+
+
5
Attach Tetra
mounting clips, leaving a 3/8 in.
(10mm) gap between sections to
allow for expansion or contraction.
Red (+)
Red (+)
Red (+)
+ –
+ –
+ –
8
Separate wires and identify outer
conductors as positive (+) and
middle conductor as negative (-).
Strip ends back 0.5 in. (13mm).
WARNING / AVERTISSEMENT
RISK OF ELECTRICAL SHOCK: Turn power OFF
before inspection, installation or removal.
RISQUES DE CHOC ÉLECTRIQUE: Coupez
l'alimentation électrique avant d'inspecter,
d'installer ou de déplacer le luminaire.
Connect four
Connect four
Connect four
positives (+)
positives (+)
positives (+)
Contour to the
®
+
+
+
6
Installation Guide
Push into clips
Push into clips
Push into clips
3
Push each 16 in. (406mm) light
engine segment into the clips. Fold
loose wires behind light engines.
Do not stretch light engines.
Cut end:
Cut end:
Cut end:
separate wires
separate wires
separate wires
6
Secure light guide by twisting
tie-wire around the mounting clip
and light guide.
Outer wires (+)
Outer wires (+)
Outer wires (+)
Middle wire (-)
Middle wire (-)
Middle wire (-)
Red (+)
Red (+)
Red (+)
Black or
Black or
Black or
blue (-)
blue (-)
blue (-)
To power supply
To power supply
To power supply
9
Connect the two outer wires (+)
from the LED strip to the red wire
(+) of the power supply. Connect
the middle wire (-) from the LED
strip to the black or blue wire (-) of
the power supply. Grounding and
bonding must be done in accor-
dance with National Electrical Code
(Article 600). See power supply
instructions.