Daintree GE current Tetra EdgeStrip HO GEBIH50-2 Manual de instalação - Página 2

Procurar online ou descarregar pdf Manual de instalação para Luz exterior Daintree GE current Tetra EdgeStrip HO GEBIH50-2. Daintree GE current Tetra EdgeStrip HO GEBIH50-2 5 páginas.

Imprimir página
Tetra
EdgeStrip HO
®
Components and Tools Required
2
1
1
UL approved 18 AWG (0.82 mm
2
UL approved 22-14 AWG (0.33-2.08 mm
connectors or 22-18 AWG (0.33-0.82 mm
connectors
3
#6 or #8 (M3 or M4) screws, 1/8 inch
(3.2 mm) rivets or electrical grade silicone
4
End caps
Tetra
24 Volt Power Supply
5
®
Tetra
EdgeStrip HO LED modules
6
®
Layout LED Modules
Sign
Modules mounted to sides
Determine location of where LED modules will
1
be mounted based on sign dimensions (see chart
on page 4). If mounting on bottom of sign, the
use of a riser will be needed (minimum 1/8 in.
distance between bottom surface and module).
Peel off backing to expose adhesive tape and stick
3
LED modules into place.
3
4
5
) supply wire
2
) wire
2
) in-line/IDC
2
T
Measure Point
C
7
Electrical grade RTV silicone.
Example electrical grade RTV silicones include:
• Momentive RTV 6700 Series Silicone Rubber
Adhesive Sealant
• Momentive White Blanc RTV 162 Silicone Rubber
Adhesive Sealant-Electrical Grade
• Dow Corning 3140 - Non-Corrosive Flowable (clear)
• Dow Corning 3145 - Non-Corrosive Nonflowable
(clear or gray)
• Dow Corning RTV 748 Non-Corrosive Sealant-White
Determine how many modules are required for
2
your application and cut where necessary.
NOTE: Cuts can be made between any of the LED
modules.
Use rivets, screws, or silicone to secure each
4
module within the sign. Use #6 (M3) or #8 (M4)
screws, 1/8-inch (3.2 mm) rivets, or silicone.
2
Installation Guide
6
7