DSC PC 2500 Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Sistema de segurança DSC PC 2500. DSC PC 2500 17 páginas.
Também para DSC PC 2500: Manual de instruções (15 páginas)

Imprimir página

MASTER CODE

The 4 digit Master Code is used for arming and disarming the system, for programming

additional access codes, and for changing other features. The Master Code will be

supplied to you by your installer. All keypad entries are made by pressing one key

at a time and may be changed by you at any time if the installer selects an option. For

additional access codes, see Programming Additional Access Codes.

ARMING

Close all protected doors and windows and stop movement in areas covered by

motion detectors. If the "Bypass" light is ON, be sure zones are being

intentionally bypassed before arming the system (see Zone Bypassing).

Check to see that the "Ready" light is ON (all zones are closed). The system

cannot be armed unless the "Ready" light is ON. Enter a [4 digit access code].

As each digit is entered, the keypad sounder will beep. Once the correct access

code is entered, the "Armed" light will come ON and the keypad sounder will

beep quickly. If the access code was entered incorrectly or the "Ready" light was

not ON, the keypad sounder will beep steadily for 2 seconds.

When the correct code is entered and the system is armed, exit through the door

indicated by your installer as the exit-entry door. The exit time may be changed

by your installer (please refer to the Quick-Arm feature).

Arming and Commercial Installations

When an Access Code is entered to arm the system, the bell or siren will sound a

short tone to indicate that the system is being armed. If your security system is

programmed to report to a monitoring station, the keypad will also sound a tone to

indicate that the monitoring station has been advised of the arming of the system.

If the system is being armed and the bell or siren fails to sound, or if the keypad

does not sound a tone to acknowledge that the monitoring station has been

advised of the arming, arrange for service for the system.

AUTO-BYPASS OPTION - HOME-AWAY ARMING

This feature, if selected by your installer, will allow you to arm your system with

any valid access code and the system will automatically bypass the interior zones

if those interior zones have been designated as home-away zones by the installer.

When activated, the "Bypass" light will come ON. If you exit within the allowed

exit time, the system will automatically reactivate the interior zones. This feature is

designed to save the user from having to manually bypass interior zones each

time they wish to arm the system and remain at home.

In residential applications where the system has been armed and the interior

zones are automatically bypassed, the interior zones can be reactivated from a

keypad outside the interior zones protection area (e.g. a bedroom). To reactivate

∗

the interior zones, press [

] then [1] and the "Bypass" light will go out.

ENTRY DELAY OFF ARMING

∗

If you wish to arm your system and eliminate the entry delay, enter [

][9] before

your access code. The "Armed" light will flash as a reminder that the system is

armed and has no entry delay. An entry through any zone programmed as a

delay zone will create an instant alarm.

∗

e.g. To arm without entry delay.....Press [

][9][Access Code]

firealarmresources.com