DSC PC1550 Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Sistema de segurança DSC PC1550. DSC PC1550 12 páginas. 4 digit master code
Também para DSC PC1550: Manual de instruções (17 páginas), Manual de instruções (17 páginas), Manual de instruções (17 páginas), Manual de instruções (9 páginas), Manual de instruções (17 páginas)

KEYPAD ZONES:

There are three zones which can be activated from the

keypad. These zones may or may not be active on your keypads depending on

how your installer has programmed them.

[F] Key:

Keypad FIRE zone. Pressing this key for 2 seconds will activate the

keypad fire zone and the bell/siren output will pulse ON and OFF.

[A] Key:

Keypad AUXILIARY zone. Pressing this key for 2 seconds will produce

a series of beeps on the keypad along with the transmission. To confirm

transmission, the keypad sounder will beep 6 times.

[P] Key:

Keypad PANIC zone. Depending on how your installer programs the

panel, pressing this key for 2 seconds may produce a completely silent alarm or

an audible alarm along with the transmission. If programmed as audible, the

alarm bell will ring.

With normal use, the system requires minimum maintenance The following

should be observed:

1. Do not wash the keypad with a wet cloth. Light dusting with a barely damp

cloth should remove normal accumulations of dust.

2. The battery/bell test is designed to determine battery condition; however it is

recommended that the stand-by battery be replaced every three years.

3. For other system devices such as smoke detectors, passive infrared,

ultrasonic or microwave motion detectors or glass-break detectors, consult the

respective manufacturer's literature for testing and maintenance.

TESTING IT IS RECOMMENDED THAT THE SYSTEM BE TESTED ON A

WEEKLY BASIS

Note: Perform such activities in the off-peak hours, such as early morning or late

evening.

1. Inform the monitoring station that you are testing your system.

2. Disarm the system ("Ready" light should be ON)

3. Perform a battery/bell test by pressing [*][6][Master Code][8]. The alarm will

sound for about 2 seconds. If a trouble occurs after the test, press [*][2] to view

the trouble condition

4. Activate each sensor in turn. For example, open a door or window. Observe

the zone light come ON as each sensor is activated. The zone light will go OFF

as each sensor is restored to normal (door or window is closed)

5. Press the [F] key. The signal will sound in a pulsed mode. Arm then disarm the

panel to silence the signal. Repeat this test by pressing the [A] key and the [P]

key in turn. Remember, the [A] key does not ring the bell and the [P] key may not