DSC PC15OO Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Sistema de segurança DSC PC15OO. DSC PC15OO 17 páginas. Pc15oo; pc155o with led615 keypad

Imprimir página

ALARM MEMORY DISPLAY

If the "Memory" light is ON, an alarm has occurred during the last armed

period. The alarm memory will automatically be displayed when the system is

disarmed (See Disarming the System).

∗

Press [

] then [3] to display the zone which caused the alarm.

Press [#] to return to Ready.

NOTE: The alarm memory is cleared each time the panel is armed so that

any alarms showing are alarms that occurred only during the last

armed period.

IF AN ALARM SOUNDS

Fire Alarm

If your system has been installed with fire detectors and the alarm sounds in a

pulsing mode, follow your Emergency Evacuation Plan immediately. See the

guide for family escape planning elsewhere in this manual.

Intrusion Alarm

If an intrusion alarm sounds (continuous Bell/Siren), the alarm may be silenced

by entering your access code. If the alarm was unintentional, call local

authorities immediately to avoid an unnecessary response.

You can determine the source of the alarm by following the instructions in the

Alarm Viewing section of this manual. Once the source of the alarm has been

corrected, the panel can be restored to its original armed state.

ZONE BYPASSING

Use zone bypassing when access is needed to part of the protected area while

the system is armed. Bypassed zones will not cause an alarm. Zones that are

temporarily out of service due to damaged wiring or contacts may be

bypassed to allow system arming (partial protection) until repairs can be made.

Zones cannot be bypassed after the system is armed.

To bypass zones:

∗

Enter [

][1][Zone number(s) to be bypassed]

Enter zone number(s) as single digits (1-6).

As each zone is bypassed, the zone light will come ON. If a zone is bypassed

in error, press that zone number again and the zone light will go OFF indicating

that the zone is not bypassed.

Press [#] to return to Ready.

To recall last group of zones bypassed:

∗

Enter [

][1][9]

Zone lights for the last group of zones bypassed will come ON to show which

zones are bypassed. If you wish to add or delete a zone from the group, press

[#] to exit then go to zone bypass as described above.

Press [#] to return to Ready.