DAITEM SH401AX Manual de instalação - Página 3

Procurar online ou descarregar pdf Manual de instalação para Sistema de segurança DAITEM SH401AX. DAITEM SH401AX 9 páginas. Indoor siren

Imprimir página

3. Recognition programming

Recognition programming allows the siren to be recognised by the control panel.
It must be done with the control panel and siren in installation mode. If they are not in installation mode, enter:
master code
IMPORTANT
• The siren does not need to be placed close to the control panel for recognition programming. In fact, it is advisable to move it
away from the panel (to a distance of at least 2 m).
• The control panel gives the siren a n° during recognition programming.
Siren recognition programming sequence
"bip"
control panel"
Briefly
Press and hold "Off"
press the siren
until the control panel
"test" button
responds

4. Setting the parameters

IMPORTANT: all parameter-setting must be done using TwinLoad
www.daitem.co.uk.
The control panel and siren must be in installation mode to set the siren's parameters. If they are not, enter:
master code
The siren's parameters are factory-programmed.
Each parameter can nevertheless be modified using the control panel keypad.
To set the siren's parameters, first choose the parameters to be modified and then enter:
siren n°
parameter
n°

4.1 Delayed alarm sounding upon intrusion

Siren alarm sounding can be delayed by 60 seconds maximum. This gives users enough time to disarm the system before
the alarm siren sounds if, for instance, they have pressed the wrong button. To delay sounding, enter:
siren n°
Factory setting: 0 s
4.2 Duration of alarm sounding
To modify the duration of sounding, enter:
siren n°
Factory setting: 90 s
then
installer code
"bip, off,
"beeeep"
)
)
)
)
)
)
10 s max.
The siren issues an
audible signal to
confirm programming
then
installer code
parameter
value
from 0 to 60 s
from 20 to 180 s
"bip, siren n°"
)
)
)
)
The control panel
announces
the siren n°
®
software available in the Daitem installers section at
3
IMPORTANT: the control panel and
siren issue three short beeps to
indicate a programming error. When
this happens, perform recognition
programming again from the start.