ansio 5006 Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Chaleira ansio 5006. ansio 5006 8 páginas. Electric glass kettle

BEFORE USING YOUR KETTLE

• Remove all the packaging from the kettle and position it on a secure,

stable, dry and flat work surface away from any edges.

• This kettle should only be connected to a British Standard power outlet

installed by an approved electrician. The kettle should not be connected

to an extension cord or plug.

• This appliance has been incorporated with a grounded plug. Ensure the

wall outlet in your house is well earthed.

• Do not let the power cord hang over the edge of a table or kitchen counter,

touch a hot surface or become knotted, trapped or pinched. While in use,

wind the excessive cord to avoid overhanging in the work surface.

• Remove the kettle from the power base and open the lid. Fill the kettle

up to the max mark and close the lid.

• Place the kettle back in its base and turn it on by pressing the switch

down.

• Clean your kettle by boiling a full kettle (1.7 L) of water twice and then

discarding the water.

NOTE: The maximum capacity of kettle is 1.7L.

OPERATION OF YOUR KETTLE

To fill the kettle, remove it from the power base and open the lid by pressing

the open lid button. Fill in with the desired amount of water, and then close

the lid. The water level should not exceed the max mark (1.7 L) or be below

min level (0.5 L) as shown in the image on Page 4. Too little water will result

in the kettle switching off before the water has been boiled.

NOTE: Do not fill the water over the maximum level, as water may spill out

of the spout when boiling. Ensure that the lid is firmly closed before plugging

the power outlet.

• Position the kettle on the power base.

• Connect the plug into a power outlet. Press the switch down. The

indicator will light up and the kettle will start to boil the water. The kettle

Customer Support – 0800 080 6781 (UK Toll Free) or +44 207 157 9795

ANSIO 5006 (M21v01)