DSC PC1550 Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Teclado DSC PC1550. DSC PC1550 17 páginas. 4 digit master code
Também para DSC PC1550: Manual de instruções (17 páginas), Manual de instruções (17 páginas), Manual de instruções (9 páginas), Manual de instruções (17 páginas), Manual de instruções (12 páginas)

If the "Memory" light is ON, an alarm has occurred during the last armed period.

The alarm memory will automatically be displayed when the system is disarmed

(See Disarming the System).

Press [ ] then [3] to display the zone which caused the alarm.

Press [#] to return to Ready.

NOTE:

The alarm memory is cleared each time the panel is armed so that any

alarms showing are alarms that occurred only during the last armed period.

If An Alarm Sounds

Fire Alarm

If your system has been installed with fire detectors and the alarm sounds in a

pulsing mode, follow your Emergency Evacuation Plan immediately. See guide

for family escape planning elsewhere in this manual.

Intrusion Alarm

If an intrusion alarm sounds (continuous Bell/Siren), the alarm may be silenced

by entering your access code. If the alarm was unintentional, call local

authorities immediately to avoid and unnecessary response.

You can determine the source of the alarm by following the instructions in the

Alarm Viewing section of this manual. Once the source of the alarm has been

corrected, the panel can be restored to its original armed state.

Zone Bypassing

Use zone bypassing when access is needed to part of the protected area while

the system is armed. Bypassed zones will not cause an alarm. Zones that are

temporarily out of service due to damaged wiring or contacts may be bypassed

to allow system arming (partial protection) until repairs can be made. Zones

cannot be bypassed after the system is armed.

To bypass zones:

Enter [ ][1][Zone number(s) to be bypassed]

Enter zone number(s) as single digits (1-6).

As each zone is bypassed, the zone light will come ON. If a zone is bypassed

in error, press that zone number again and the zone light will go OFF indicating

that the zone is not bypassed.

Press [#] to return to Ready.

To recall last group of zones bypassed:

Enter [ ][1][9]

Zone lights for the last group of zones bypassed will come ON to show which

zones are bypassed. If you wish to add or delete a zone from the group, press

[#] to exit then go to zone bypass as described above.

Press [#] to return to Ready.