Anslut 012425 Manual de Instruções - Página 11
Procurar online ou descarregar pdf Manual de Instruções para Luz de inundação Anslut 012425. Anslut 012425 12 páginas. Floodlight with motion detector
Imprimir página
SAFETY INSTRUCTIONS
•
Designed for indoor and outdoor use.
•
Battery powered only.
•
Do not mix old and new batteries, or
batteries of different types, for example
rechargeable batteries and non-
rechargeable batteries. Replace all the
batteries at the same time. Insert the
batteries with the correct polarity.
•
Battery fluid from leaking batteries can
cause burns on the skin. Wear safety gloves
if you need to handle leaking batteries.
•
Never modify the product, this can
invalidate the warranty.
•
The product must be discarded if the glass
front is cracked.
•
The LED light source is not replaceable.
When the light source has reached the
end of its useful life the complete product
must be replaced.
•
Remove the batteries if the product is not
going to be used for some time.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle end-of-life product
in accordance with local
regulations.
TECHNICAL DATA
Battery
Output
Protection rating
Luminous flux
Colour temperature
Lighting-up time
Detection range
Light sensitivity
ASSEMBLY
POSITIONING
•
The product should be mounted on a
wall.
•
The ambient temperature affects the
range of the motion detector. The product
should therefore not be placed near
sources of heat, such as air conditioning
units, fans and ventilation openings,
outlets from ovens or heaters, or pointed
at a bright, reflective surface.
PREPARATIONS AND MOUNTING
1.
Carefully remove all the parts from the
packaging and place them on a smooth,
horizontal surface.
2.
Undo the screw on the bottom edge of
the product and remove the wall bracket.
FIG. 1
3.
Remove the battery cover by pressing in
both tabs.
FIG. 2
4.
Insert four batteries (sold separately).
Replace the battery cover by pressing it in
place until it clicks.
FIG. 3
5.
If the product is to be mounted on a
concrete wall, first drill two holes in the
wall. Put in expander plugs, align the wall
bracket to the holes and screw it in place
EN
4 x 1.5 V C/LR14
9 W
IP44
600 lm
4000 K
3 s – 7 min
Max 8–10 m
20–20000 lux
11