Anslut 008088 Manual de Instruções - Página 9

Procurar online ou descarregar pdf Manual de Instruções para Lanterna Anslut 008088. Anslut 008088 10 páginas. Solar cell lighting

SAFETY INSTRUCTIONS

The product is only intended for outdoor,
decorative lighting.
The product is not a toy. Keep children
under supervision to make sure they do
not play with the product.
Do not use the product near flammable
materials.
Do not expose the battery to naked flames
or heat.
The lamp and solar panel are weather
resistant, but do not immerse them in
water or any other liquid.
Do not look directly into the light source
when it is switched on.
The light source is not replaceable. Discard
the product if it stops working.
Do not attempt to charge batteries with a
battery charger that is connected to the
mains, and do not attempt to run the
product from the mains.
RECHARGEABLE BATTERIES
IMPORTANT:
When replacing batteries – only use
rechargeable batteries.
Always buy the correct size and type of
battery intended for this purpose.
Remove the batteries from the product if
it is not going to be used for some time.
Recycle used batteries in accordance with
local regulations.
SYMBOLS
Approved in accordance with
the relevant directives.
Class III.
Recycle discarded product as
electrical waste.

TECHNICAL DATA

Battery
Luminous flux
Safety class
Protection rating
USE
POSITIONING
Place the product so that it is exposed to
full sunlight at least 6 hours per day. Battery
charging and lighting up are reduced in
the shade. The product can switch off
automatically if put near strong sources of
light, such as street lamps.
USING FOR THE FIRST TIME
Put the power switch in the ON position.
The protective paper must be removed from
the battery on some models. The product is
controlled automatically by a light sensor. The
product switches on automatically at sunset
and runs on the energy stored in the battery.
Switch off the product, or replace the protective
paper, to save energy. If the product does not
light up automatically at sunset, check:
1.
That the switch is in the ON position.
2.
That the solar panel is in a position where
it is exposed to direct sunlight
EN
1.2 V AA
10 lm
III
IP44
9