ANSMANN WL 200R Manual de operação - Página 4

Procurar online ou descarregar pdf Manual de operação para Luz de trabalho ANSMANN WL 200R. ANSMANN WL 200R 16 páginas.

Imprimir página

SCOPE OF DELIVERY

WL200R Workshop lamp

USB power supply 5V/500mA

USB/Micro-USB charging cable 150cm

Manual

FUNCTIONAL OVERVIEW

Professional workshop lamp with the latest SMD LED technology

Robust plastic housing with rubber-coated grip

Can be swivelled through 340°, lamp grip can be locked in twelve positions for flexible

direction of the light

Fastening magnet on the bottom of the grip

Fold-out hook on the top of the housing can be swivelled through 360°

Integrated belt clip on the rear of the housing

Light with two light functions (100% / 50% light power)

Permanently installed Li-ion rechargeable battery pack (3.7V / 1550mAh)

Charging possibility via USB mains adapter (110V-240V) or USB car adapter (12-24V)

Charge monitoring via coloured LED on the rear side of the lamp

TECHNICAL DATA

Integrated illuminants:

3.25W

Lighting intensity:

Luminous flux:

Battery life:

Input voltage for the external mains adapter:

Charge time:

USE

The on/off switch for the workshop light can be found on the top of the housing:

Press 1x: The WL200R workshop lamp will be switched on in 100% light mode.

Press 2x: The workshop lamp illuminates at the 50% setting.

Press 3x: The lamp is switched off.

CHARGING PROCEDURE

Charge the workshop lamp fully before using for the first time. If the workshop lamp has been

stored for an extended period of time it should likewise be fully charged again before first

use.

The following charging options are available:

Via USB mains adapter plugged into the mains outlet

Via USB car adapter connected to the cigarette lighter of the vehicle

Via USB cable connected to a third party device with a USB output port (e.g. PC, laptop)

To charge the WL200R workshop light, pull the sealing cap off the micro-USB socket on the

rear of the lamp. Connect the USB mains adapter / USB vehicle adapter with the WL200R

workshop lamp by plugging the micro-USB plug on one end of the USB / micro-USB charge

cable provided into the micro-USB socket on the light and plugging the USB plug on the other

end of the charge cable into the USB socket of the USB mains adapter / USB vehicle adapter.

Then plug the USB mains adapter into a mains outlet or plug the USB vehicle adapter into the

cigarette lighter of the vehicle. To charge the workshop light with a third party device, plug

the USB plug on the charge cable into the USB socket of the third party device after having

first connected the micro-USB plug on the other end of the charge cable with the workshop

lamp as described above.

CHARGE STATUS INDICATION

The WL200R workshop lamp has a professional LED status indicator on the rear of the lamp

(besides the charging socket). The LED illuminates red during the charge procedure and

illuminates green once the battery pack is fully charged.

The WL200R workshop lamp is protected against over-charging. This means that you can

leave the workshop lamp connected to the charging power after its rechargeable battery

pack has been fully charged.

English

Deutsch |

main light 5x SMD LEDs, Nominal power

400 Lux at 0,5m distance

220 Lumen

ca. 3.5h (100% light power)

ca. 10h (50% light power)

100-240V AC / 50-60Hz

ca. 4,5h