DSE 8660 Instruções de instalação

Procurar online ou descarregar pdf Instruções de instalação para Controlador DSE 8660. DSE 8660 2 páginas.

Imprimir página

TYPICAL WIRING DIAGRAM

A larger diagram is available in the operators manual.

Deep Sea Electronics Plc.

Tel:+44 (0)1723 890099

Fax: +44 (0)1723 893303

LO CALL (from UK BT landlines) :

Telephone 0845 260 8933

Email: [email protected]

Deep Sea Electronics inc.

Phone: +1 (815) 316-8706

8706

Fax: +1 (815) 316- 8708

8708

TOLL FREE (USA only) : Tel: 1 866 636 9703

Email: [email protected]

Web: www.deepseausa.com

D E E P S E A E L E C T R O N I C S

8 6 6 0 I N S T A L L A T I O N I N S T R U C T I O N S

I N S T A L L A T I O N I N S T R U C T I O N S

ACCESSING THE FRONT PANEL CONFIGURATION EDITOR.

THE FRONT PANEL CONFIGURATION EDITOR.

Ensure the engine is at rest and the module is in STOP mode by pressing the Stop/Reset

•

Press the Stop/Reset

and Info

•

If a module security PIN has been set, the PIN number request

If a module security PIN has been set, the PIN number request is then

•

shown :

Press

(up) or

(down) to adjust it to the correct value.

•

Press

(right) when the first digit is correctly entered. The digit you have just entered will now

when the first digit is correctly entered. The digit you have just entered will now

•

show '#' for security.

•

Repeat this process for the other digits of the PIN number. You can press

to move back to adjust one of the previous digits.

•

When

is pressed after editing the final PIN digit, the PIN is checked for validity. If the number is

not correct, you must re-enter the PIN.

•

If the PIN has been successfully entered (or the module PIN has not been

en successfully entered (or the module PIN has not been

enabled), the editor is displayed .

EDITING A PARAMETER

Enter the editor as described above.

•

Press the

to cycle to the section you wish to view/change. Then press

to cycle to the section you wish to view/change.

to cycle to the parameter within the section you have chosen.

within the section you have chosen.

To edit the parameter, press

to enter edit mode. The parameter begins to flash to indicate that

•

you are editing the value.

Press the up or down buttons to change the parameter to the required value.

change the parameter to the required value.

•

Press

to save the value. The parameter ceases flashing to indicate that it has been saved.

•

To exit the editor at any time, press and hold the

•

NOTE: When the

NOTE: When the editor is visible, it is automatically exited after 5 minutes of inactivity to

editor is visible, it is automatically exited after 5 minutes of inactivity to

ensure security.

NOTE: The PIN number is automatically reset when the editor is exited (manually or

NOTE:

The PIN number is automatically reset when the editor is exited (manually or

automatically) to ensure security.

NOTE:

NOTE: More comprehensive module configuration is possible using the

NOTE:

More comprehensive module configuration is possible using the

More comprehensive module configuration is possible using the 86

More comprehensive module configuration is possible using the

configuration software. . . . Please contact us for further details

configuration software

Please contact us for further details

NOTE: The contents of the tables overleaf may differ depending on the actual module

configuration.

buttons simultaneously.

it to the correct value.

number. You can press

ceases flashing to indicate that it has been saved.

button.

86xx series PC

xx series PC

053-070

ISSUE 1

button.

(left) if you need