DSE RE-HDMI-RG Manual do Proprietário

Procurar online ou descarregar pdf Manual do Proprietário para Transmissor DSE RE-HDMI-RG. DSE RE-HDMI-RG 4 páginas. The transmitter and receiver for hdmi over coax transport

Imprimir página

OWNER'S MANUAL

RE-HDMI-RG

The transmitter and receiver for HDMI over coax transport

Product description

The HDMI (High Definition Multimedia Interface) is an all-digital commercial standard for the interface of the audio and video signals in high resolution. Our next-generation DVR all use this output for

connection to both TV-like monitor that computer in high resolution.

HDMI is an excellent door from the performance point of view, but it is not simple to conduct cable.

The standard HDMI cable allows you to carry the HDMI signal only for a few meters. With special and very expensive HDMI cables can also get to 20 meters, but no further.

To overcome this limitation these RE-HDMI-RG transmitters allow to carry the HDMI signal up to the maximum distance over 500 m using 75 ohm coaxial cable such as RG59, 179, 6, 11 etc. very common in

analog CCTV.

Package Contents

Receiver transmitter

2 feeders 220VAC / 5VDC

Installation

The product consists of a transmitter to be connected to the video source (DVR) and a receiver which connect the TV or monitor. It must be careful not to reverse the two elements: the transmitter is marked

by TX written while the receiver RX wrote.

Both the DVR that the monitor are connected to TX and RX HDMI cable with a short (1-2 m. Not supplied). The coaxial cable to carry the signal transport connects with F-type connectors (produced in the

female connector), those normally used in satellite TV and cable.

Here we report, for example, the receiver connections

1 - F connector for coaxial cable

2 - yellow LINK LED (only receiver). It lights up when the connection is established with the transmitter. 3 - Reset button

4 - HDMI to connect the equipment (DVR to TX and RX to monitor) 5 - 5VDC power supply socket included

Transmitter and receiver are connected to each other with a 75 Ohm coaxial cable. They are good both large coaxial as RG69, RG6, RG11 is minicoassiali as RG179. Consider that the system involves the

use of a cable of at least 20 m in length. The connection to a coaxial cable of a few meters will not work without the insertion of the attenuators. You can be inserted along the coaxial cable of the signal

splitters (active, not simple T BNC), realizing in this way the connection between a transmitter and multiple receivers.

DSE srl - Digital Surveillance Equipment - WW.DSE.EU

Document: RE-HDMI-RG 1F6

RE-RG-HDMI transmitter and receiver for HDMI

Page: 1