DSPeaker Anti-Mode X2 Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Hardware de rede DSPeaker Anti-Mode X2. DSPeaker Anti-Mode X2 12 páginas.

1.Overview

✔ The Anti-Mode

X2 unit

✔ A power supply for your country / region

✔ A calibration microphone

✔ An infra-red remote controller (with batteries)

✔ This guide

Not included

✔ USB Type-C cable is not included

The remote control layout is depiceted on the right. When this guide references a

button, it usually refers to a press of the corresponding button.

center button (Ok / Confirm).

Anti-Mode

X2 is an automatic room & speaker optimizer with a preamplifier function. Running the

automatic calibration procedure using the provided microphone is required to utilize the optimization

feature and to establish the correct speaker configuration when a subwoofer is used. See Chapter 2

Calibration on page 9 for details.

Connect the left and right outputs to a pair of powered speakers or to your amplifier. If you have a

subwoofer, connect it to the "sub" output connector. Up to 3 digital audio sources can be connected:

Optical S/PDIF using Toslink, USB Audio 1.0 using USB-C, and Coaxial S/PDIF. If an analog audio source is

connected to the "Line In" inputs, the Coaxial S/PDIF connector can not be used at the same time.

Then connect the power supply to the wall socket and the plug to the

Power input of the Anti-Mode X2. The unit will automatically start and show

"X2" on the screen. After that "0.0" is shown shortly if there is no

calibration data. "2.0" or "2.1" is shown otherwise, depending on the mode

chosen in a previous calibration.

If your amplifier doesn't have a gain setting or it is set quite high,

remember to check the volume setting of the Anti-Mode X2 before proceeding. The default volume is

-40dB, you may need to increase it for normal operation.

Rev. 1.1

2022-08-10

represents the

-M

NTI

ODE

SER

UIDE

Page 4 (12)