ATTACK FD42 Manual de instruções de utilização - Página 11

Procurar online ou descarregar pdf Manual de instruções de utilização para Caldeira ATTACK FD42. ATTACK FD42 16 páginas. Fd series. floor standing cast-iron solid fuel burning boiler

Imprimir página

b) Assembly of the control rod of chimney flap

Assembly of the control rod of the chimney flap is done in this way::

- punch holes in the skeleton (in the right lateral side)

- insert the rod pos. 2 through the right lateral side

- at the end of the rod fix a ball pos. 3

- mount the lever pos.1 on the axis of the chimney flap.

- the rod pos. 2 insert into the lever pos. 1. Slip a washer pos.7 on the

rod from both sides. After slipping lock with a pin pos. 8. On the rod

put a screw, washer, and a nut pos. 4, 5 a 6. Tighten the screw slightly.

Test the function of the flap. If needed, adjust the angle of slipping and

tighten the screw firmly.

12. Brazier grid assembly

If needed ( the brazier grid is not supplied with the boiler), the assembly is carried out by following steps (fig.3):

- Preraziť the card on the side of the front element in the bottom part, between the front and intermediate element using a bit of

make a hole as in fig.3,

- place the back grid (12) in the combustion chamber,

- place the front (10) and block it to the hub (9) with the screws (8) and the nuts (7), block the front grid from the right

side of the boiler body with the screws (5)

- hook the tie rod (6) to the seats extracted from the front and rear grids (11).

- introduce the ring (4) and the lever (3) on the hub (9), fixing then everything with the washer (2) and the screw (1).

LEGEND

1 Left side

2 Right side

3 Posterior superior boardt

4 Protection deflector

5 Control board

6 Cover

Obr. 6

LEGEND

1 M8 x 10 screw

2 Washer

3 Grid lever

4 Ring for lever

5 M8 x 35 screw

6 Tie rod

7 M 10 nut

8 M 10 x 50 screw

9 Hub

10 Front grid

11 Intermediate grid

12 Rear grid

Ż 10 mm

Fig

. 3