DSPPA PAVA9500E Manual - Página 8

Procurar online ou descarregar pdf Manual para Amplificador DSPPA PAVA9500E. DSPPA PAVA9500E 10 páginas. 8-zone amplifier host with main/backupswitching

Imprimir página

PAVA9500 (8-Zone Amplifier Host with Main/Backup Switching Function)

PAVA9500E (8-Zone Expansion Amplifier with Main/Backup Switching Function)

1— Power Switch

2—AC230V Power Input Interface

3—8 Channels of Speaker A&B Loop Output Interfaces

 If the detection function is enabled, the line open-circuit, short-circuit or ground fault will be alarmed accordingly

based on the device enabling settings on the PC control software.

 If the detection function is disabled, no loop detection will be performed and all zones are in normal state.

 It can be connected to external custom speakers or three-wire sound control.

 Output voltage: 0~100V.

4—8 Channels of DC24V Output Interfaces

 In EMC mode (host EVAC/ALERT, host EMC MIC, fireman microphone ECAV/ALERT, fireman microphone EMC MIC,

fireman FUNCTION 1-6, fire dry contact trigger), the DC24V output is forcibly enabled. The timing point can allow

you to select whether to enable DC24V output or not.

 It can be connected to external four-wire sound control.

 The rated output current is 0.2A per channel.

Note: The total power of 8-channel outputs shall not exceed 38W.

5—8 Channels of Programmable Dry Contact Output Interfaces

 The timed output of any dry contact can be programmed and configured.

 The triggered output of any dry contact can be configured for a fire alarm input signal.

6—8 Channels of Programmable Input Contact Interfaces

 It can be configured in two ways: dry contact input and level input.

7—System Host / Expansion Host Module Configuration Switch (Down for "Enabled", Up for "Disabled")

 System host:

"1" - indicates the master detection switch of the system, "enabled" for monitoring the working status of each module

of the system, otherwise "disabled".

"2" - indicates trigger mode configuration switch, "enabled" for short-circuit triggering, "disabled" for level triggering.

"3" for none.

"4" - indicates default value resetting of the host IP. IP address: 192.168.5.192; port number: 10086.

[email protected]

www.dsppatech.com

The specifications will be subject to change without prior notice.