DSR DSR5221 Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Carregador de bateria DSR DSR5221. DSR DSR5221 12 páginas. Pro series

FEATURES

CHARGING THE INTERNAL BATTERY OF THE BOOSTER

IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE AND AS OFTEN

AS POSSIBLE. THE BOOSTER CAN BE LEFT PERMANENTLY CONNECTED TO THE AUTOMATIC

CHARGER. NEVER WAIT UNTIL THE BOOSTER IS COMPLETELY DISCHARGED BEFORE RECHARGING.

6.1 Digital Display on the Booster

When not connected to a vehicle battery and when the booster clamps are stored on their plastic storage

holders:

A – With the rotary switch in the OFF position: the digital display can be used to indicate the percent of charge of

the voltage of the booster's internal battery.

To check the internal battery's charge status, press the display button on the front of the booster. The digital

display will show the battery's percent (%) of charge. A fully charged battery will read 100%. Charge the internal

battery if the display shows it is under 100%.

B – With the rotary switch in the ON position: Select the voltage 12V (or 24V), the digital display can be used to

check the voltage level of the booster's internal battery. The display will indicate the battery's voltage.

NOTE: The internal battery's percent of charge or Voltage level is most accurate when the booster has been

disconnected from all devices and charging sources for a few hours.

6.2 LED Indicators on the Charger

POWER (green) LED lit: The charger is connected to AC power.

CHARGING (yellow/orange) LED pulsing slowly: The charger is charging the battery inside the booster

or is in maintaining mode.

CHARGING (yellow/orange) LED flashing rapidly: The charger has detected a problem with the battery.

See Troubleshooting section for more information.

BAD BATTERY (red) LED lit: The charger has detected a problem with the battery.

See Troubleshooting section for more information.

1. 12V DC power outlet

2. Jump starter ON/OFF switch –

DSR5221: OFF or 12V position

DSR5222: OFF, 12V or 24V position

3. Digital display

4. Display button

5. USB button

6. USB Port

7. Heavy-duty battery clamps

8. Charger

9. Power LED

10. Charging status LED

11. Bad Battery LED

• 5 •

9 10 11