Attero Tech unDIO2x2 Manual do utilizador - Página 12

Procurar online ou descarregar pdf Manual do utilizador para Acessórios Attero Tech unDIO2x2. Attero Tech unDIO2x2 17 páginas. 2-in/2-out dante interface
Também para Attero Tech unDIO2x2: Manual do utilizador (16 páginas)

Imprimir página

1. Ip Address Setup

unDIO2x2

User Manual

Once the required software is installed, click on the unIFY Control Panel icon in the programs list under Attero Tech.

This will start the application.

Figure 8 – Device Configuration Window

3.3 – Selecting a Network Adapter

In order to connect to a device the application needs to know what network adapter it should use to contact devices.

Clicking on the networked PC icon

will show a list of all possible adapters.

*Note: Only network adapters that are deemed as being compatible with Dante will be shown in the list.

3.4 – Connecting to a Device

A few seconds after selecting the adapter, the device list should start to populate with detected devices. The detected

devices are listed by their device name. Select the device to be configured from the drop down list and then click the

"Connect" button. The application will then attempt to establish a connection with the device. If successful, the status

bar will show "Connected" and the controls will become active and their values will update to show the current state of

the device.

*Note: The label below each set of channel controls show that channels name as displayed in Dante Controller. The

channel name cannot currently be set from within the unIFY application. To change the channel names, use Dante

Controller.

This connected device is now treated as the active device and any changes to the controls will be set to this device and

this device alone.

Page 11

614-00013-05