Attero Tech CommandHub Manual do utilizador - Página 17

Procurar online ou descarregar pdf Manual do utilizador para Hardware de rede Attero Tech CommandHub. Attero Tech CommandHub 20 páginas. Unify proxy device for control and routing

Imprimir página

4.2.8 – Network State Changed (Asynchronous)

This command is used to asynchronously notify a 3

command can be used as a trigger for the 3

devices. For example, if a Dante device goes off-line, the Network State Changed command will be asynchronously sent

out each active TCP connection, if a controller is listening for the message they can then query for the updated device list

to see which device has gone offline.

*Note: The CSTS command is used to enable and disable the NSTC command.

Start

Character

0x02

Change Status Byte Return Values:

This value is an integer value of a bitmask where the following represents the bits in the mask:

•

000 – change detected but unknown change

•

001 – device list changed

•

002 – channel routing changed

•

004 – device clocking status changed

Example asynchronous notification: (example – detected a device & routing has changed)

party controller that the Dante network state has changed. This

party controller to query the CommandHub to get an updated status of

Command

(ASCII)

Represents value

pre-pended with '0'

NSTC

Table 14 - NSTC Command Format

Page 16

CommandHub

Status

(8 ASCII)

Characters

00000000

0x03 0x07 0x04

User Manual

Stop

614-00019-01