DSYS DL4B Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para Luz de trabalho DSYS DL4B. DSYS DL4B 8 páginas. Mini rc led lighting

Imprimir página
Universal RC
LED Lighting
Car / Boat / Plane / BUS, TIR, Tractor, Tank, Dinghy, Sub, Glider.
W - resistant to splashing water, snow, humidity and dust.
Plug the control cable to the receiver (channel ESC, servo or free). Plug
the servo cable in to connector K2, which is connected to the control
cable. Vývody LED zkraťte na délku 5mm. Solder the wires to
connector's counterparts. Cut the LEDs lead to 5mm length, extend
the leads with wires and isolate them properly.
LED polarity: flat side (usually shorter lead)
is negative (Cathode).
Each pin L1-L4 maintains a current of 40mA. By parallel connection of
LEDs the current is divided into 20 + 20mA. You can connect only the
same LED types in parallel. If you connect one 3V LED to any L1 - L4
pin, then connect R1 150R resistor
in parallel, Connect 120R in parallel to one 2V
LED (current is divided into 20 + 20mA).
Powering LEDs from the Receiver (4 - 8V). Connect the LEDs
cathodes to L1-L4 connector pins. Connect the LED's anodes to +L.
When using 2V LEDs (red), you can connect two parallel connected
LEDs or 2x two parallel connected LEDs in series.
When the voltage drops under 5V the LEDs light intensity decrease.
right
/ left
L1
right
/ left
L2
right
/ left
L3
right
/ left
L4
2
WIRING
+L Power LED (anode)
LED application examples
Car. L1: reflector, L2: front, L3: inner, L4: rear
Boat. L1: Mast, L2: front, L3: cabin, L4: rear
Aeroplane. L1: reflector, L2: landing, L3: beacon, L4: position
RC Models
DL4B
+A
Lx
Connector K1
Connector K2
+L
L1
L2
L3
F1
L4
Connector K3
Jumper
(Set)
DL4BW
-C
-C
+A
R1
Control
cable
F1-F6
RC
receiver