DT Research DT301Y Manual de operação básica - Página 4
Procurar online ou descarregar pdf Manual de operação básica para Tablet DT Research DT301Y. DT Research DT301Y 4 páginas. Rugged tablet
Também para DT Research DT301Y: Manual de operação básica (4 páginas), Manual de operação básica (4 páginas), Manual de operação básica (9 páginas)
Imprimir página
Replacing the Battery Pack
1. Slide the battery latch to the unlocked position.
2. Lift the battery pack off the compartment.
3. Fit another battery pack into place.
4. Slide the latch to the locked position.
5. If you want to purchase extra battery packs,
please contact your dealers, or visit our Support
page:
https://www.dtresearch.com/en/
Support/contact.html
CAUTION:
There is danger of explosion if the battery is incorrectly replaced. Replace the
battery only with the Tablet manufacturer's battery. Discard used batteries
according to the dealer's instructions.
CAUTION:
Do not attempt to disassemble the battery pack.
Battery Usage and Maintenance
DT Research tablets and laptops are powered by lithium polymer battery packs in
proprietary form factors. Battery configurations for the DT Research devices include
internal (bridge or backup), removable or swappable implementations.
Battery usage cycles, or duration between necessary re-charge, vary with a number
of factors, including device model, device usage pattern and battery health/aging.
The DTR battery packs may be charged while attached to the device or when sepa-
rated from the device and docked in proprietary battery charging cradles. Following
the guidelines on good practice below can help to keep a battery pack healthy and
prolong battery usage cycles and battery lifespan.
•
Avoid high heat conditions during operation, idle, charging, and storage states.
•
Avoid letting the battery pack remain in very highly charged state or overly low
charged state for extensive periods of time. Keeping the battery capacity between
30% and 80% of maximum capacity is recommended. The prevailing battery
level(s) can be read from the Battery utility within the Windows operating system.
•
Avoid letting the battery be over-discharged or depleted. Over-discharge can
occur when a fully-discharged (0% level or thereabouts) battery pack is allowed
to remain in such a state for an extended period of time (weeks or months).
The embedded battery controls enter a protection mode and recharging will be
prevented for safety reasons. To reduce the likelihood of over-discharge, consider
recharging idle batteries regularly to some level between 30%-80% of capacity.
•
For long term storage, it is recommended that removable battery packs be stored
separated from the device. Otherwise, the system should be placed in Shutdown
mode. The battery level will decrease with time and it is recommended that the
battery packs be monitored or recharged every 2-3 months to maintain battery
health. The targeted battery level should be within 30% to 80% of maximum
capacity.
6
2
2
1
3
4
Federal Communication Commission Interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
Product End-of-Life Notice
For reuse and recycling facilities, please visit below link to get disassembly
instructions:
http://www.dtresearch.com.tw/zh/About/csr.html
http://www.dtresearch.com.tw/EPEAT/DT301Y_Product_End-of-Life_Disassembly_
Instructions.pdf
or
7