Attwood 13710-4 Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Sistemas de elevação Attwood 13710-4. Attwood 13710-4 2 páginas. Anchor lift system

2. To raise the anchor, rotate the lift handle CLOCKWISE.

Figure D

CAUTION!

The rope reel release knob and the lift handle only operate in a clockwise direction.

Operating these in a counter clockwise direction may cause damage.

ATTWOOD ANCHOR LIFT SYSTEM CARE:

1. The Anchor Lift System comes completely lubricated from the factory with

waterproof grease; however lubrication is recommended periodically to maintain the

product in good working order.

2. The amount of use and exposure your Anchor Lift System is subjected to will

determine the frequency of the required lubrication of the product. The Anchor Lift

System Anchor Mount / Rope Guide and Anchor Rope Reel Assembly should be

covered when not in use and, if used in salt or brackish waters, should be ﬂ ushed

with fresh water to remove all salt residues.

Lubrication:

1. To lubricate the reel assembly use a waterproof grease spray or grease tube with

a long nozzle and insert into the lube opening located under the long slot handle

assembly. Rotating the reel during this process will help to move the grease over

the internal component surfaces.

Figure E

2. To properly lubricate the reel internal axle assembly you will need to remove the

rope from the reel. Apply grease into the slot in the reel axle shaft and rotate the

reel to spread and coat the internal axle.

3. Reinstall the rope on the reel. Make sure that you clean up any grease residue prior

to installing rope on the reel to avoid soiling the rope.

4. To lubricate the Anchor Mount / Rope Guide use a light duty penetrating oil to spray

the shafts of the rollers allowing the penetrating oil to work under the rollers. Avoid

spraying directly on the anchor rope.

Figure F

Discover other anchors & docking on our website.