Bourgault L7550 Manual de referência rápida

Procurar online ou descarregar pdf Manual de referência rápida para Balanças Bourgault L7550. Bourgault L7550 6 páginas. Weigh scales

Imprimir página

www.bourgault.com

1. Weigh Scales Setup

a. When the system is powered up there

should be a Digi-Star UT app loaded

for each Scale Link installed on the rear

axle of the unit (2 UT apps for units

with 2 Scale Links installed).

Digi-Star Scale

Link App

b. After the implement profile for the

specific unit is created and the Apollo

ECU's are detected go to the Imple-

ment/Apollo Seeder/Seeder/Weigh

Scales/ECU tab on the Settings page

Scale Link 1: Tanks 1-4

Scale Link 2: Saddle Tank

Press the Auto Detect and Assign New

ECU's button to detect the Scale Link

ECU's.

ii. For the 9000 A/C there will be a Scale

Link ECU 1 for Tanks 1-4. If equipped

with the Saddle Tank there will be a

Scale Link ECU 2 for Tank 5.

iii. This Auto Detect feature applies

to units that have specific settings

loaded into the respective Scale

Link ECU to detect in the correct

order.

iv. If the weight values are not showing

up for the correct tanks they are

likely detected in the wrong order.

Press the delete button then leave

the page and come back to detect

in the correct order by unplugging

the 6 pin cable on the Scale Link

ECU 2 for the Tank 5, pressing

the Detect New ECU's button and

then plugging the Scale Link ECU

2 back in and pressing the Detect

New ECU's button again.

P/N 0256-80-12

Assy P/N 0256-80-13

Weigh Scales - Quick Reference Guide

c. On the Implement/Apollo Seeder/

Seeder/Weigh Scales/Scales tab you

need to confirm that the Setup and

Calibration numbers are correct for

each channel specific to your model.

Scale Link 1

Scale Link 2

i. These values should already be set

correctly from factory but if you get

an alarm for "Mismatched Setup

or Calibration Numbers" or the

weights don't seem accurate then

these values should be confirmed.

Refer to the Tables on Page 2.

ii. Simply by viewing this Scales tab

on the X35 settings page and then

switching to a different page it will

send these values from the X35 to

the Scale Link ECU.

iii. If you still get this Mismatch

alarm you can set the values on the

Digi-Star UT app for each channel

by pressing the Cycle screen button

twice. Then you can set the appro-

priate values for each channel.

iv. The Affects Scale column for the

9000 A/C should be set to None for

each tank.

Channel

(v. 5.02 revised Jan 2023 )

Cycle Screen

Page