3onedata IES6100 Series Manual de instalação rápida - Página 3

Procurar online ou descarregar pdf Manual de instalação rápida para Interruptor 3onedata IES6100 Series. 3onedata IES6100 Series 4 páginas. Managed industrial ethernet switch

Imprimir página
Provide 1 program debugging port based on RS232 serial port
which can conduct device CLI command management after
connecting to PC. The interface adopts RJ45 port, the RJ45
pin definition as follows:
Pin No.
2
3
Definition
TXD
RXD
【Antenna Connection】
Model III and IV provide 2 WIFI antennas, the antenna
specifications are shown below:
Type
P/N
Gain (dBi) Quantity (pcs)
2.4G
3005040056
5
wireless
【Checking LED Indicator】
Provide LED indicators to monitor its operating status, which
has simplified the overall troubleshooting process. The
function of each LED is described in the table below:
LED
Indicate
Description
Power is connected and
ON
running normally
PWR/P1/P2
Power
OFF
disconnected or running
abnormally
Power supply or the port
ON
link is alarming.
ALM
Power supply, port link
OFF
without alarm
The device is powering on
ON
or the device is abnormal.
The device is powered off
OFF
RUN
or the device is abnormal.
Blinking
Blinking
second, the device is
running normally.
Ethernet
Link/Act
ON
established
(1-8/9)
network connection
Blinking
Ethernet port
5
GND
2
【Logging in to WEB Interface】
Support WEB management and configuration. Computer can
supply
is
access the device via Ethernet interface. The way of logging
in to device's configuration interface via IE browser is shown
as below:
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed
Enter device's IP address in the address bar of the
computer browser.
1
time
per
Enter device's username and password in the login
window as shown below.
port
has
a
valid
is in an
active network status
Ethernet port has not
OFF
established valid network
connection
The left light 1
The WiFi function of this
is on
device is enabled
The left light 1
The WiFi function of this
is off.
device is disabled
The device is in AP mode;
The right light
Or the device is in bridge
2 and 3 are off
mode, but the bridging is
unsuccessful.
The device is in bridge
The right light
mode, and the bridge
2 or 3 is on
signal strength is weak
The device is in bridge
The right light
mode, and the bridge
2 and 3 are on
signal strength is strong
Click "OK" button to login to the WEB interface of
the device.
Note:
The default IP address of the device is "192.168.1.254".
The default user name and password of the device are
"admin".
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【Specification】
Panel
100M copper port
10/100Base-T(X) self-adapting
RJ45
port,
self-adaption or forced working
mode,
self-adaption
100M fiber port
100Base-FX, 1×9 interface
Console port
CLI command management
port (RS-232), RJ45
half/full
duplex
support
MDI/
MDI-X