AddEnergie SmartTWO Manual de instalação - Página 17

Procurar online ou descarregar pdf Manual de instalação para Carregador de bateria AddEnergie SmartTWO. AddEnergie SmartTWO 20 páginas.
Também para AddEnergie SmartTWO: Manual de início rápido (4 páginas)

Imprimir página
Station Head and Connector Installation
2
2
3
1
© 2019 ADDÉNERGIE TECHNOLOGIES INC. ALL RIGHTS RESERVED Information and specifications contained in this document are subject to change, amendments and additions at any time, without notice
Installation of the charging station head on its base
1. Unscrew the charging port holder
2. Remove the charging port and cable assembly
2.1 Dsconnect the three positions connector
2
connector
2
3
2.2 Unscrew the two brackets
2
3
4
3. Slide the head into the base
1
1
Important:
- Do not slide the head down with excessive force. If
the head doesn't slide down into position easily, gentle
shake the base of the charger head while guiding it into
the base.
- Be careful not to damage the black plastic connectors
on the bottom of the charger head on the top of the
base.
- Once fully inserted, the spacing between the head and
the base should be from 0 à 3mm
3
Installation of the charging coupling connector
2
3
1
1. Screw the bracket back into place
2. Connect the three positions connector
1
be on the right) and the small black connector
3. Screw the charging port holder back into place
2
2
Make sure the bottom of the charging port holder does not interfere
with the base.
*
WARNING: Never use a power tool to install the security
screws, and never apply a torque of more than 18 Nm
(160 pound-inches) when tightening them.
4
.
2
3
3
.
1
.
2
3
1
1
2
3
1
.
2
(green connection should
2
3
3
4
3
3
1
1
2
and the small black
3
1
.
.
1
1
17