AdDent Calset Instruções de utilização

Procurar online ou descarregar pdf Instruções de utilização para Equipamento dentário AdDent Calset. AdDent Calset 2 páginas. Composite warmer

Imprimir página
calset accessory part #s:
P/N 600003 - Standard Tray
P/N 600067 - Tri-Tray
P/N 600047 - Dispenser Tray
P/N 600059 - Anesthetic Tray
P/N 600064 - 7 Hole Tray
P/N 600066 - Porcelain Veneer Tray
ManUfactUrer
AdDent, Inc.
43 Miry Brook Road, Danbury CT 06810
Phone: 203-778-0200
Fax: 203-792-2275
Website: www.addent.com
ADDENT, INC. 43 MIRy BROOK ROAD, DANBURy CT 06810
EMAIL: [email protected] | WEBSITE: WWW.ADDENT.COM
!
ISO CERTIFIED
PHONE: 203-778-0200 | FAx: 203-792-2275
General
The Calset unit is designed to heat composite material, anesthetic solution and porce-
lain veneers. The Calset unit accepts composite from compules or syringed material.
A tray placed on the top of the heater will either hold compules, or will have a holder
for your composite dispenser. There are other trays available and are described in
Intended Use.
!
A plastic spatula should always be used to remove composite to avoid
scratching the non-stick surface.
If the Compule Tray is used, it is recommended that the compule be placed in the
composite dispenser immediately after it is warmed and placed in the mouth within 30
seconds.
Intended Use
The basic Calset unit is used for warming dental composite materials. Accessories for
the Calset are as follows:
1. Tri-Tray – For warming composite inside of dispenser gun to 155°F (68°C),
a nd warming 2 finishing instruments. 3 extra compules may also be warmed. If
using the AdDent CoMax Composite Dispenser, the Tri-Tray enables you to pick
up the compules without touching the compule
2. Dispenser Gun Tray – For warming composite inside of dispenser gun to
155°F (68°C).
3. Anesthetic Carpule Tray – For heating anesthetic compules to 98°F (37°C).
4. Syringe Tray – for heating the syringed material to 155°F (68°C).
5. Porcelain Veneer Tray – for heating the composite in the back side of the veneer
to 155°F (68°C). Keep lid on for 3 minutes of warming.
descrIptIon of UnIt
A universal power supply (100-240 VAC, 50/60 hertz) provides power to the heater. A
circular control housing contains a microprocessor and the heater assembly. Around
the perimeter of the housing are the power connector, a control switch, and 2 LED
lights. The housing has a non-stick coated metal top plate to conduct the heat from
the heater to the tray. The tray has a cover and a plastic ring assembly to enable
the hot tray to be picked up comfortably. The Calset will turn off after 10 hours of
unattended use.
INSTRUCTIONS FOR USE