Comtrend Corporation PG9141s-PoE Manual de instalação rápida - Página 6
Procurar online ou descarregar pdf Manual de instalação rápida para Adaptador Comtrend Corporation PG9141s-PoE. Comtrend Corporation PG9141s-PoE 7 páginas. Powerline ethernet adapter with wifi
Imprimir página
2. ETHERNET LED is OFF: If the ETHERNET LED fails to light up,
check that the LAN port of the PowerGrid unit is connected firmly to
the LAN port of the other device. To check the condition of the
Ethernet cable, use another cable to test the same connection.
3. STATUS LED is OFF: Plug both PowerGrid units that you're
attempting to pair into power outlets that are within the same room;
both PowerGrid devices should have an Ethernet cable connected to
their respective devices (e.g. PC, Router, Set Top Box, camera, etc.).
After 10 seconds (approximately, until all the LEDs of the device
blink), the STATUS LED should light up GREEN. If not, press the
"Config" button on each for 2-5 seconds and let go.
* If you have tried all of the above and are still experiencing problems, you can reset
both devices to factory default by using a pin - PowerGrid 9141s and button -
PowerGrid 9142s to push the "Reset" button of each device for 11 seconds. The WPS
LED will flash every second. After the "Reset" button is released, the WPS LED will be
steady ON for around 5 seconds, then the system will reboot to factory defaults.
PowerGrid 9142s
SURGE PROTECTED POWER STRIPS: Avoid plugging
PowerGrid units into power strips with surge protection as
this will reduce network speed and may even prevent
their use.
FOR MORE HELP: If you have further questions or require personal
assistance, please contact your equipment supplier or service provider.
Reset
PowerGrid 9141s
Reset
Page 6