Comtrol RocketPort 485 Series Cartão de instalação de hardware - Página 7
Procurar online ou descarregar pdf Cartão de instalação de hardware para Placa PCI Comtrol RocketPort 485 Series. Comtrol RocketPort 485 Series 8 páginas.
Imprimir páginaRocketPort 485 Card
Baud Rate:
RS-232 DTE (4J, 8J,
Quad/Octacable
models)
RS-232/485 (models
with interface box)
Note: Baud rate is dependent upon hardware and
operating system configuration.
Bus interface
Note: EISA files are on the Diagnostics diskette.
Control by device driver:
Data bits
Parity
Stop bits
Current Consumption
(Values do not include
the power supplied to
external devices on
Ports 3 through 8.)
Dimensions
Heat output
Interfaces:
All models
With optional RS-485
feature enabled on
Ports 1 and 2
Interrupt (software
selectable)
Mean time between
failures (MTBF)
Power consumption
RocketPort cards/system
Surge protection
with standard interface
box
Interface Box
Mounting
Type
Dimensions
RS-232/485,
3.37" x 2.69"
8-Port
RocketPort® 485 Hardware Installation Card
Specification
50 to 460.8K bps
(without interface box)
50 to 460.8K bps
(with interface box)
ISA
7 or 8
Odd, Even, None
1 or 2
+5V
+12V
-12V
350 mA 110 mA 160 mA
6.25" by 4.2"
16.6 BTU/Hr
RS-232
RS-458
None, 3, 4, 5, 9, 10, 11, 12, 15
20.5 Years
4.87 W
4
Provides ESD surge
protection exceeding 10 KV.
Overall
Dimensions
3.68" x 3.6" x 1.6"
FCC Notices
Radio Frequency Interference (RFI) (FCC 15.105)
This equipment has been tested and found to comply with the
limits for Class A digital devices pursuant to Part 15 of the FCC
Rules.
This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try and correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the
receiver.
•
Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
Labeling Requirements (FCC 15.19)
This equipment complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received, including
interference that may cause undesired operation.
Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly
approved by Comtrol Corporation may void the user's authority to
operate this equipment.
Serial Cables (FCC 15.27)
This equipment is certified for Class A operation when used with
shielded cables.
7 of 8