Comunello BELL B45 50Nm Instruções - Página 4

Procurar online ou descarregar pdf Instruções para Motor Comunello BELL B45 50Nm. Comunello BELL B45 50Nm 4 páginas.

Imprimir página
MOTOR INSTALLATION
Step 1 Cut drive tube to required length.
②Drive Adapter
③Circlip
Step 3 Mount correct crown & drive adapter on the motor. Make sure drive
adapter fits firmly and crown rotates freely.
CAUTION
•
Do not expose motor to humid or extreme temperature conditions.
•
Do not drill into motor.
•
Do not cut the antenna and keep it clear from metal objects.
•
Do not allow children to play with this device.
•
If power cable or connector is damaged, do not use.
•
Ensure correct crown and drive adaptor are used.
•
Ensure power cable and aerial is clear and protected from moving parts.
•
Cable routed through walls shall be properly isolated.
•
Motor is to be mounted in horizontal position only.
•
Before installation, remove unnecessary cords and disable equipment not needed for powered operation.
•
Installation and programming to be performed by a qualified professional, use or modification outside the scope of this instruction may void warranty.
UPPER AND LOWER LIMITS SETTING
1 Set upper limit
1
Set upper limit
→
+
+
UP
Press UP, motor runs upwards, when it is necessary to increase the upward
distance, use a special adjustment lever to rotate the white worm toward the "+"
direction, operate the motor to desired upper position, immediately stop rotating
the white worm and press STOP once to set the upper limit successfully.
*If an external receiver is used, the emitter is used to control the motor operation. If an external switch is used, the switch is used to directly control the motor
operation.When the motor is in the stop state, it is forbidden to rotate the white-red worm with the adjustment lever.
TROUBLESHOOTING
Issues
The motor has no response
The motor doesn't run or starts too slowly
or make loud noise
The motor stops during the going up or
going down.
Drive tube
①Crown
→
→
The upper
limit position
STOP
Possible causes
Power Failure Or Incorrect Connection
Connections are incorrect.
Incorrect installation or overload
The motor has reached the lower limit
Running time exceeds 4 min
Drive tube
Step 2 Ensure tube edge is clean and burr-free.
Bracket
Step 4 Align the notches on the crown and drive adapter with the drive tube, slide
and fit the motor into drive tube.
Mount idler and bracket on both ends.
2 Set lower limit
2
Set lower limit
→
+
+
DOWN
Press DOWN, motor runs downwards, when it is necessary to increase the
downward distance, use a special adjustment lever to rotate the red worm toward
the "+" direction, operate the motor to desired lower position, immediately stop
rotating the red worm and press STOP once to set the lower limit successfully.
Double check power and cable connections, follow wiring instructions.
Check connections
Check installation or overload
Adjust the new lower limit
Consult the sales for more information
Bracket
The lower
→
→
limit position
STOP
Solution
91300648 - REV.00 - 15/16/23
4