Conair 17 PIECE HC117WCSC Instruções de utilização e cuidados - Página 3
Procurar online ou descarregar pdf Instruções de utilização e cuidados para Máquina de barbear eléctrica Conair 17 PIECE HC117WCSC. Conair 17 PIECE HC117WCSC 8 páginas.
Imprimir página
the hair against the direction in which it
grows.
T h e n e v e n i t u p w i t h t h e s i d e s .
For a flat top, use the flat comb, not the
attachment comb. Just cut hair on top of
the head over the flat comb. (see Fig. 2).
To taper hair down to the neckline, use
attachment comb #1. Comb hair and
check for uneven spots. Outline sideburns
and neck areas (see "Outlining").
USER-MAINTENANCE
INSTRUCTIONS
CARE OF YOUR CLIPPERS
IF YOU DETERMINE THAT BLADE
ALIGNMENT IS INCORRECT:
MAINTENANCE OF THE BLADE
Always apply oil to the blades before, during
and after use. This will ensure maximum
cutting performance. Hold clipper away from
your body in a downward position and apply
oil on the front and sides of the cutter blade.
Wipe excess oil off with a soft dry cloth.
®
Conair
hair clippers are carefully
inspected to insure that the blades are in
perfect alignment. You will need to realign
the blades after removing them for cleaning
or replacement, or if they should be
knocked out of alignment. How can you tell
if the blades need realigning? Simply
match them up, point for point, to conform
with the drawing below.
To replace cutting comb and cutter after
removal for cleaning, replacement or,
because they are out of alignment, slide the
cutter back on to the black plastic oscillating
head. Next, you must make sure that the
cutter (small blade) and the cutting comb
(large blade) are properly aligned. Line up
the new or existing cutting comb with the
two screw holes. Place the original screws,
one in each hole, and lightly tighten with a
Phillips head screwdriver.
Fig. 1
Large blade (cutting comb)
Blade screws
Small blade (cutter)
Then, match the two blades up, point to
point, conforming with the illustration below
in (Fig. 2).
Fig. 2
Cutting Comb (large blade)
Cutter
(small blade)
*The top edge of the cutting comb should
be 1/32" to 1/16" (.79 mm. to 1.59 mm.)
higher than the top edge of the cutter. This
is important so that the clipper does not cut
too close, or come in contact with the skin.
*The extreme left-hand tooth of the cutting
1/32" to 1/16"