Conair 27 PIECE HC275WC Instruções de utilização e cuidados - Página 4
Procurar online ou descarregar pdf Instruções de utilização e cuidados para Máquina de barbear eléctrica Conair 27 PIECE HC275WC. Conair 27 PIECE HC275WC 11 páginas. Haircut kit
Imprimir página
with the two screw holes. Place the original
screws, one in each hole, and lightly tighten
with a Phillips head screwdriver.
Large blade (cutting comb)
Blade screws
Small blade (cutter)
Then, match the two blades up, point to point,
conforming with the illustration below in (Fig. 1).
Cutting Comb (large blade)
Cutter
(small blade)
FIG. 1
*The top edge of the cutting comb should be
1/32" to 1/16" (.79 mm. to 1.59 mm.) higher
than the top edge of the cutter. This is impor-
tant so that the clipper does not cut too close,
or come in contact with the skin.
*The extreme left-hand tooth of the cutting
comb must cover or be to the extreme left
hand of the first small tooth of the cutter.
*Be sure that the extreme right hand big tooth
of the cutter touches the extreme right hand
tooth of the cutting comb.
SPECIAL OIL
To maintain the blades of your Conair
clipper, oil them after every three or four hair-
cuts. Gently place a few drops of oil on the
teeth of the blades, using the special Conair oil
included with your
set. Turn the clipper
on for a minute,
then turn off. This
light, natural oil was
formulated specifically for the Conair high
speed clipper. Because it is the right oil to use,
it will not slow down the blades. Never use any
other product. There is no substitute for
Conair oil.
1/32" to 1/16"