Conairphone TAD2018 Manual do Proprietário - Página 10
Procurar online ou descarregar pdf Manual do Proprietário para Atendedor de chamadas Conairphone TAD2018. Conairphone TAD2018 17 páginas. Callkeeper digital answering system
Imprimir páginaSpecial Features (Cont.)
Toll Saver (TS)
Your unit has a built-in automatic toll
saving feature. This feature lets you know
if you have received any messages before
it answers, thus saving you on long
distance costs.
How Toll Saver Works
IF YOU HAVE SET THE RING
SELECT SWITCH TO TOLL
SAVER(TS), when calling your unit from
a remote location to check for messages,
listen to the number of rings:
1. If your phone rings more than two
times, you have no messages. You can
hang up on the third ring before your unit
answers, and save the cost of the call.
Note:
If no messages are received, your unit will
answer the call after the fifth ring.
2. If your unit answers after only 2 rings,
you have received new messages.
Remote Operation
Remote Security Code
To access answering functions from an
outside line, you will need to enter the
three digit security code located on the
bottom of your unit.
Remote Turn On
1. Call your unit from a touch-tone phone.
2. Wait 10 rings until the machine
answers.
3. The TAD2018 will automatically
answer by playing your greeting. You
may hang up the phone, and subsequent
calls will be answered.
Remote Message Playback
1. Call your unit from a touch-tone
telephone.
2. After your TAD2018 answers, it plays
the outgoing greeting and beeps once.
Dial your three digit security code within
10 seconds after the beep, pressing and
holding each digit for 1-2 seconds. Allow
a 2 seconds interval between each digit.
3. Your unit will emit 4 short beep tones
once correct code is detected and
playback all incoming messages. After the
last message your unit will emit 4 short
beep tones.
4. To repeat the remote message playback,
dial your 3 digit security code again
within 10 seconds of the last 4 beep tones.
5. To end the remote message playback,
hang up. All messages are automatically
saved and your unit will reset itself to
answer the next incoming call.
Remote Message Erase
1. After listening to your messages, the
unit will emit 4 short beep tones, pause
for 10 seconds and emit one beep tone.
2. Immediately after this single beep tone,
dial your 3 digit security code, pressing
and holding each digit for one full second.
3. Your unit will emit 4 short beep tones
and disconnect the line. All messages will
be automatically erased and your system
will reset itself to answer the next
incoming call.
10