Dan D'Agostino Momentum Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Dan D'Agostino Momentum. Dan D'Agostino Momentum 13 páginas. Hd preamplifier
Também para Dan D'Agostino Momentum: Manual do Proprietário (13 páginas), Manual do Proprietário (10 páginas), Manual do Proprietário (15 páginas), Manual do Proprietário (11 páginas), Manual do Proprietário (11 páginas)

oPeRation

Initial power-up of the amplifier

The power button is located on the front underside edge of the amplifier. Pressing the

button will power up the amplifier.

After power is switched on, the Momentum amplifier requires approximately 30 minutes to

reach optimal operating temperature. Although the amplifier will sound excellent upon initial

listening, the sound quality will improve as it warms up, much as the flavor of a fine red wine

improves if it is allowed to breathe for a few minutes.

During operation

The Momentum amplifier requires no adjustments during normal operation. If there is no

sound or the sound quality is in some way impaired, consult the "Troubleshooting" section

in this manual.

Power meter settings

Two toggle switches on the back panel control the brightness and sensitivity of the power

meter. In order to prevent accidental operation, these switches are partially recessed.

Use your finger to gently move the switches.

Brightness switch: This switch has three positions. Move it to the left (when looking at the

amp from the rear) for high brightness and to the right for low brightness. If the switch is in

the center position, the meter will be turned off.

Sensitivity/meter off switch: If you listen at low levels, the needle on the meter will not move

dramatically; this switch allows you to get more action out of the meter. Move the switch to

the left (when looking at the amp from the rear) for 30-watt sensitivity and to the right for

150-watt sensitivity. In the center position, the meter will read 300-watt sensitivity.

The Momentum amplifier requires no user maintenance other than to keep it clean and

ensure that the vents remain unobstructed.

To clean the amplifier, first disconnect the AC plug. Spray a small amount of the supplied

cleaning solution onto the supplied microfiber cloth and gently wipe the amplifier's surface.

Do not spray the cleaner directly onto the amplifier.

If dust or other contaminants or objects collect around the heat sink venturis or the vents at

the top and bottom of the amplifier, remove small objects by hand and use a shop vacuum or

hand vacuum to remove the dust. Use a brush attachment on the vacuum to avoid scratching

the amplifier's surface.