Dan D'Agostino Momentum Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Dan D'Agostino Momentum. Dan D'Agostino Momentum 15 páginas. Hd preamplifier
Também para Dan D'Agostino Momentum: Manual do Proprietário (13 páginas), Manual do Proprietário (13 páginas), Manual do Proprietário (10 páginas), Manual do Proprietário (11 páginas), Manual do Proprietário (11 páginas)

Remote control input

This is a standard iC5-type 3.5 mm input for a remote control signal. it can be used with home

automation systems, or with the included iR module when the preamp is installed in a cabinet or

other place where it is not in line of sight with the remote control.

RS-232 input

This DB9-type input allows the Momentum preamp to be controlled by home automation systems

that use the RS-232 protocol. Consult your D'Agostino Master Audio Systems dealer for more

information. Current code is available online at www.dandagostino.com

oPerAtIoN

Initial power-up of the preamplifier

To power-up the Momentum preamplifier, you need to use two switches. One is located on

the back of the power supply; this switch turns the AC power on so the power supply will be

active. The other is the Standby button located on the front of the preamp.

First, flip the switch on the back of the power supply to the On position. Then press the

Standby button on the front of the preamp. This will power up the preamp and illuminate the

volume indicator.

After power is switched on, the Momentum requires approximately 30 minutes to reach

optimal operating temperature. Although the preamp will sound excellent upon initial

listening, the sound quality will improve as it warms up, much as the flavor of a fine red wine

improves if it is allowed to breathe for a few minutes.

The Momentum preamp offers only a few basic functions: power on/off, volume, source selection,

phase and mute. Operation is simple but a brief description follows.

standby: The Standby button is located on the front panel of the preamp. When the preamp is

in standby (Off) mode, the LeD in the middle of the button will be lit in yellow. Push the button to

turn the unit on. When power is on, the LeD in the middle of the button will go off and the volume

indicator will illuminate. Push the button once more to turn the unit off. The light for the volume

indicator will go out and the LeD in the middle of the Standby button will light up.

Volume: Turn the ring around the volume indicator clockwise to raise the volume and

counterclockwise to lower it, or use the Volume +/- buttons on the remote. The needle indicator

will move toward the right as you increase the volume and to the left as you decrease it. We

recommend you turn the volume down when you initially power up the system, and raise it only

when you are assured that all components in the system are operating properly.