DAN DRYER 659 Instruções de instalação - Página 2
Procurar online ou descarregar pdf Instruções de instalação para Electrodomésticos DAN DRYER 659. DAN DRYER 659 3 páginas. Safety baby changing station
Imprimir páginaRead the installation instructions thoroughly before commencing installation.
The design of the safety baby changing station makes it easy to mount in even very small
rooms. The changing table must be mounted onto a wall which is suited to carry the
weight of the table as well as a baby – preferably a solid wall! For indoor use only.
Where to mount the Baby Changing Station
Determine the ideal place to mount the baby changing table. Keep in mind that the depth
of the changing table is 625 mm in open position. The distance from the floor to the lower
edge of the table mountings should be approx. 750 mm (see FIG. 1). Doorways, sinks etc.
should of course also be taken into consideration when choosing where to mount the
changing table.
IMPORTANT: Do NOT mount the table in a chlorine-containing environment!
Marking and drilling holes
To mount the changing table onto brick, gas concrete or the like, use 10 mm screws and
matching universal plastic dowels – e.g. Fischer fixings type S-12. When mounting the
changing table onto a cavity wall of min. 16 mm (or 2 x 13 mm) plaster board, we
recommend prior mounting of a reinforcement plate of stainless steel, plywood or the like,
onto which the changing table is subsequently mounted. Attach reinforcement plate to the
wall using a considerable number of special metal cavity fixings, Fischer part. no. BC
62328 or equivalent (part. no. BC 62315 for double plate). The changing table itself is also
mounted with these screws and dowels – plus one metal washer per screw hole. For
further details, please refer to the instructions of the dowel supplier. In places where
plaster walls have not yet been finished, we suggest mounting a 16 mm plywood board on
the inside of the plaster wall, rendering the need for a reinforcement plate on the outside
unnecessary. Mark and drill holes as indicated on FIG. 1. The top holes for the table
mountings should be drilled into solid brick - not into a joint.
Mounting the Baby Changing Station
➊ Disassemble the cover plates of the table mountings by removing the 6 screws
(3 on each) with a Torx screwdriver no. 20.
➋ Mount the table onto the wall, making sure that it is completely level.
➌ The baby change unit is factory pre-adjusted to easily close when given a slight push
from open position.
➍ Check that the changing table is mounted solidly onto the wall.
➎ Check that the shock absorbers can pass freely when opening and closing the table.
➏ Reassemble the cover plates onto the mountings.