ADDER AdderLink X-Series Manual - Página 5

Procurar online ou descarregar pdf Manual para Extensor ADDER AdderLink X-Series. ADDER AdderLink X-Series 18 páginas. Usb extender
Também para ADDER AdderLink X-Series: Manual (15 páginas)

Imprimir página

Installation

The installation of the USB Extender set is straightforward and can best be

achieved in most cases by following these stages for each module:

•

Mount the module

•

Connect the cables

Mounting a module – desk or rack

The USB Extender modules can be situated

on a desk (or floor) or alternatively, for larger

installations, mounted within optional rack

mount chassis units.

Desk mount

Apply the supplied self-adhesive rubber feet to

the underside of the module(s).

Rack mount

Note: The module switches are not accessible once it is inserted into the rack,

therefore, check all settings before insertion.

1 Place the rack securing plate (available as a separate kit) onto the front of the

module and secure it with the two countersunk screws.

2 Orient the module on its side so that its labelled face is the correct way up and

the securing plate is facing away from the rack.

3 Slide the module into the required rack position. The rectangular cut-out in the

front upper lip of the rack allows the two screws on the module's upper edge to

slide through.

4 The rack mount chassis has a series of holes in its floor that are spaced to

accommodate the two screws on the module's lower edge. Ensure that the

screws correctly locate into the two holes of the chosen slot. The rack securing

plate on the module should now be flush with the front of the rack mount

chassis.

5 Use the third (pan-head) screw, in the top hole of the rack securing plate to

fasten the module to the rack.