Conceptronic CSM3PL Instruções de atualização do firmware - Página 4
Procurar online ou descarregar pdf Instruções de atualização do firmware para Leitor multimédia Conceptronic CSM3PL. Conceptronic CSM3PL 7 páginas.
Também para Conceptronic CSM3PL: Instruções de atualização do firmware (6 páginas)
Imprimir página
4. Checking the current firmware version
4.1 Make sure the CSM3PL is connected to a TV or monitor.
4.2 Press the "SETUP" button on the remote control.
4.3 Highlight the "FIRMWARE VERSION" option. The firmware version is displayed on the lower left
corner. This should be "CSM3PL_FW_VER_1.58D".
4.4 If the displayed version isn't the same as the version described at point 4.3, then you need to
repeat the upgrade procedure as described in chapter C.
D. Upgrade procedure from a USB stick or memory card
1. Copying the firmware files to a USB stick or a memory card
1.1 If you have downloaded the firmware upgrade from www.conceptronic.net, you have a ZIP file
containing a folder named 'Firmware' and three documentation files.
1.2 Connect the USB stick or memory card to your computer.
1.3 Copy the 'Firmware' folder including all its content to the USB stick or memory card.
1.4 Remove the USB stick or memory card from your computer with the 'Safely remove hardware'
option.
1.5 Disconnect the USB stick or memory card from your computer.
2. Updating the firmware
2.1 Make sure the CSM3PL is connected to a TV or monitor.
2.2 Turn on the CSM3PL with the remote control.
2.3 Connect the USB stick to the CSM3PL or slide the memory card in the right card slot of the
CSM3PL.
2.4 A screen will be displayed in which you can make the choice between 'HARD DISK' and 'USB
DEV' / '<memory card>', where '<memory card>' is the used memory card type (for instance
'COMPACT FLASH'). Choose the option of the USB stick or memory card.
2.5 Select the 'Firmware' folder by using the navigation buttons on the remote control.
A confirmation screen will be displayed asking if you want to replace the current firmware with a
new one. Choose 'Yes'. The upgrade process will start. This is visible in the upper left corner
with the terms 'ERASE' and 'WRITE'.
Note:
The CSM3PL must not be turned off during the upgrade process. Doing so will
result in an unusable product which is not covered by the warranty.
®
Copyright
2008 by Conceptronic – All rights reserved
www.conceptronic.net
Page 4 of 7