Duco DucoBox Silent 325 Manual de instalação - Página 9
Procurar online ou descarregar pdf Manual de instalação para Ventilador Duco DucoBox Silent 325. Duco DucoBox Silent 325 16 páginas.
Também para Duco DucoBox Silent 325: Manual de início rápido (16 páginas), Manual de instalação (12 páginas), Manual de instalação (16 páginas)
Imprimir página
06.E Pairing components
Never pair more than one system with RF components at the same time. If you do so, a component in the wrong
network could be paired, e.g. in the neighbours' DucoBox.
Pairing components on the DucoBox Silent Connect
Activate 'Installer mode' by tapping 'INST' on the DucoBox� The LED
1
will flash green rapidly�
Add control components by tapping once on the component to be
paired� The LED will flash red briefly and then start to flash green
rapidly� Repeat this step until all remaining components in the cur-
rent zone have been paired�
2
With RF components: start with the component closest to the mas-
ter� If the first pairing is unsuccessful, another component may be
tried first, which can then act as a hop point for components which
are unable to make an RF connection with the DucoBox�
Once all components have been paired, 'Installer mode' can be
deactivated by tapping 'INST' on the DucoBox Silent Connect� LEDs
3
on all components will stop flashing�
Please refer to the manual with the components for more detailed information�
06.F Removing / replacing components
Removing paired components from the network or replacing is only possible within 30 minutes after the component is paired in
or is restarted� Restarting can be done by disconnecting the power for a moment� After a time-span of 30 minutes, remove and
replace operations are ignored� This is valid for all components from date of manufacture 170323�
Removing a component
Activate 'Installer mode' by
long-pressing 2 diagonal buttons
1
on a paired control� The LED will
flash green rapidly�
Press once and hold a button on
the component to be removed
2
in order to remove it from the
network�
Deactivate 'Installer mode' by
pressing the 4 buttons on a paired
control simultaneously (or using
3
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
Replacing a component
Activate 'Installer mode' by
long-pressing 2 diagonal buttons
1
on a paired control� The LED will
flash green rapidly�
5 sec
Press briefly twice on the button
2
of the component to be replaced�
5 sec
Tap once on the button for the new
component� The latter will take on
3
all settings / connections in the
network�
Deactivate 'Installer mode' by
pressing the 4 buttons on a paired
control simultaneously (or using
3
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
Example of a pairing sequence
1
8
2
3
4
indicates the order in which a
X
button of the component must be
pressed controls component
L2000641 Installation guide for DucoBox Silent (Revision G | 17.07.2019)
ENGLISH
5
7
6
5 sec
OLD
2x
NEW
1x
9