addi Express Kingsize Manual de instruções - Página 13

Procurar online ou descarregar pdf Manual de instruções para Máquina de costura addi Express Kingsize. addi Express Kingsize 16 páginas.
Também para addi Express Kingsize: Manual (20 páginas)

Imprimir página
addi Express Kingsize Manual de instruções
Introduction to addiExpress ingsize
— 1
— 3
— 2
— 4
1 /
2 /
3 /
6
6 —
1 — YARN-HOLDER
2 — REPLACEMENT NEEDLES
3 — ROW COUNTER
4 — PLASTIC NEEDLE
5 — TABLE CLAMPS
6 — OPERATING SWITCH
— 5

SETTING UP

1 / Screw the four legs into the designated holes on
the bottom.
2 / Place the addiExpress Kingsize at the edge of the
table and affix it with the two support clamps.
3 / To set the line counter to 0, turn the black knob.
1 /
2 /
3 /
4 /
5 /
6 /
7 /
8 /
9 /
10 /

Introduction to circular knitting

All of the 46 needles are used
1 / Before you start with circular knitting, set the
operating switch in the down position to "Circular
knitting".
2 / Pull some of the thread off and through the
middle of the addi- Express until it touches the table.
Then wrap the yarn around the black needle on the
right. (There are three needles, a left, middle and
right)
3 / Start slowly turning the handle clockwise, while
doing this, alternate the position of the yarn from in
front of to behind of the rising needles.
4 / When you reach the first black needle (the right
one) again, the yarn runs outward.
5 / Open the yarn holder by pushing it open to the
left. Place the yarn halfway. To start it is essential
to close the yarn holder to avoid damages at the
needles.
6 / Whether you place the yarn halfway or entirely
into the yarn holder, depends on the yarn. It should
run smoothly.
7 / You can now begin. Do not use force while
turning the handle clockwise - it must move smooth.
If you have the feeling that the stitches are not
positioned on the needles tightly enough, simply
pull at the bottom of the knitted piece.
8 / When you have reached the desired lenght of
your item you have to cast off: Cut the yarn off to 35
inches, pull it through the yarn holder and thread it
into the plastic needle.
9 / While slowly turning the handle go through
each of the stitches alternating from going through
the front of and back of the lowered needle. The
suture retainer must remain closed during this time,
as otherwise the needle may become damaged.
10 / You must do this to the right of the yarn holder.
Your item is now done when all stitches are cast.
7