ANZ POS Turbo 2 Manual de referência rápida - Página 3

Procurar online ou descarregar pdf Manual de referência rápida para Terminal de pagamento ANZ POS Turbo 2. ANZ POS Turbo 2 4 páginas.

Imprimir página

CONFIGURING COMMUNICATION MODE

If you require your terminal to change communication

modes between GPRS, Dial-up and IP, please follow the

steps below.

<Func>

1. Press

9, 9, 0, 5 and then press

2. At "Swipe Merchant Card" Press

<ENTER>

3. Press

to go to" COMMS MODE" Screen

4. Press 1 to select Dial-up communication mode

Press 6 to select GPRS communication mode

Press 7 to select IP communication mode

<ENTER>

5. Press

until the ANZ main screen appears

<Func>

2, 4, 6, 8 <ENTER><ENTER>. "TMS

6. Press

Logon Successful" should display on the terminal.

7. Press

<Func>

8, 7 <ENTER><ENTER>. "ANZ

Initialisation Approved" should display on the

terminal.

TERMINAL FAULTS – SELF HELP

If your terminal is experiencing technical issues (e.g.

blank/frozen screen), attempt the following steps:

<Func>

8, 6 <ENTER><ENTER>. The terminal

1. Press

will Power Reset.

<Func>

2, 4, 6, 8 <ENTER><ENTER>. "TMS

2. Press

Logon Successful" should display on the terminal.

<Clear>

Press

to go to Main Screen.

3. Press

<Func>

8, 7 <ENTER><ENTER>.

"ANZ Initialisation Approved" should display

on the terminal.

Press

<Clear>

to go to Main Screen.

The terminal is now ready to process transactions.

If the above steps are unsuccessful, switch off the

power at the power point. Leave the power off for 5

minutes. Ensure cables are securely connected. Switch

on power at the power point. Repeat steps 2 & 3. If

unsuccessful please contact ANZ Merchant Services on

1800 039 025 for further assistance.

Note: For Dial Up terminals only – If you are experiencing a 'No

Line' message on your terminal, you will need to test your PSTN

(Phone Line) by plugging a telephone into the wall socket &

dialling 1800031002. If you do not hear a fax sound you may

need to fault your line to your phone service provider.

<ENTER>

INSTALLING A PAPER ROLL

•

When the paper roll is nearing the end, a red line

will appear on the paper, this indicates that the

paper roll must be replaced.

•

Open the paper compartment by pulling the cover

towards the rear of the terminal

•

Insert the paper roll in the compartment

•

Pull the paper end up to the top of the terminal

and hold it in position

•

Maintain the paper roll position and close the lid

•

Press the top of the lid in the centre until it clips

into position.

TERMINAL SECURITY

Please ensure that the terminal is placed in a secure

location enabling the cardholder to use the keypad

without being observed by security cameras, CCTV

devices or by any other person.

Only authorised ANZ business partners are permitted

to install or perform maintenance of your terminal.