DUERR 424/LCD/20 Manual - Página 5

Procurar online ou descarregar pdf Manual para Cortador de lenha DUERR 424/LCD/20. DUERR 424/LCD/20 16 páginas. Vertical log splitters
Também para DUERR 424/LCD/20: Manual de instruções (17 páginas)

Imprimir página
DUERR 424/LCD/20 Manual
IMPORTANT
ASSEMBLY
This unit has been shipped without
gasoline or oil in the engine. After
assembly, refer to separate engine
manual for proper fuel and engine oil
information.
UNPACKING
Remove all parts from the carton. Make certain all
parts and literature have been removed from the
carton before the carton is discarded.
Reservoir Tank
Assembly
FIGURE 1
FIGURE 2
Hub Cap
U
^ NOTE
All hardware for assembly of the log
splitter has been placed in position on
the various parts.
Other Materials Required for Assembly:
Wheel Bearing Grease
Loc-tite Hydraulic Sealer or Equivalent
Engine Oil
Unleaded Gasoline (regular grade gasoline is an
acceptable substitute)
Approximately 6-1/2 Gallons of 10 Weight AW type
fluid or Dexron II Automatic Transmission Fluid
Loose Parts in Carton: (See figure 1)
(1)
Reservoir Tank Assembly
(2)
Wheels
(1)
Wedge and Beam Assembly
(1)
Tongue Assembly
(1)
Pivot Latch
(1)
Hitch Assembly
(1)
Engine and Pump Assembly
(3)
Hoses (taped together)
(1)
Cylinder and Valve Assembly
(1)
Stripper Assembly (two halves)
(2)
Fenders (Not Shown —Model 424/LCD/20)
(1)
Filter Head*
(1)
Hydraulic Filter*
*May be already assembled to the reservoir tank.
INSTALLATION OF WHEELS
Attach the wheels to the reservoir tank as follows.
See figure 2.
1.
Pry off the hub caps which are attached to the
wheels. Remove one tapered roller bearing from
inside each wheel. See inset, figure 2.
2.
Remove the cotter pin, hex slotted nut and one
flat washer from each axle (leave spacers and
two flat washers in place on axles).
3.
Place one wheel on each axle, with the
valve
stem facing outward.
4.
Pack the tapered roller bearings with wheel
bearing grease, and place one on each axie.
5.
Place one flat washer removed in step 2 on each
axle. Secure with hex slotted nut. Tighten
slotted nut until snug, then back off approx¬
imately 1/3 turn or until one of the slots on the
slotted nut lines up with the hole in the axle.
6.
Check the assembly of the wheels. There should
be no side to side play, and the wheels should
spin freely.
7.
Place hub caps in position on wheels and tap
on with a rubber mallet or plastic hammer.
5