Duevi RX2 AP Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Recetor Duevi RX2 AP. Duevi RX2 AP 4 páginas. 2 channels wireless receiver

Imprimir página

RX2 AP: 2 channels wireless receiver

Warning:

WHERE THE PRODUCT IS INSTALLED. DUEVI DECLINES ANY RESPONSIBILITY IN CASE OF

IMPROPER USE OF THE CUSTOMER OR WRONG INSTALLATION.

DO NOT INSTALL THE DEVICE IN HUMID LOCATIONS OR EXPOSED TO EXTREME

TEMPERATURES. FOR A SOLID AND RELIABLE IMPLANTATION IT IS INDISPENSABLE TO

MAKE SURE THAT THE SURFACE OF THE WALL IS FLAT. FIX THE DEVICE AT AN HEIGHT

THAT ALLOWS AN EASY ACCESS FOR THE USER. INSTALL THE DEVICE IN A LOCATION

COVERED BY A VOLUMETRIC DETECTOR.

DUEVI DECLINES ANY RESPONSIBILITY IN CASE OF IMPROPER USE OF THE CUSTOMER.

EVENTUAL MODIFICATIONS CARRIED OUT FROM NOT SPECIALIZED STAFF CAN DAMAGE

THE DEVICE.

RX2 AP is a 2 channels self-learning receiving device with 2 independent relay outputs. Each channel may

store up to 5 wireless devices (sensors and remote controls). Each channel is related to a relay output with

voltage-free contacts, that can be used as needed.

The device, enclosed in a plastic case, has an integrated antenna and allows to use wired control panels with

the Duevi series wireless detectors.

Code 1

Code 2

Code 3

Code 4

Code 5

1. MEMORY TOTAL RESET

Before using the receiver, it is advisable to make a total reset of the memory, in order to delete any codes that

may be programmed in factory test.

Press and maintain pressed the button S1 while giving power supply to the device. Continue to press the

button until, after about 5 seconds, you will ear 3 short beeps followed by a long one. Now you can release the

button. The Reset is completed.

2. WIRELESS CODE PROGRAMMING

To enter in this mode, you have to close the jumper JP2.

The device will emits 2 beeps and will light on Ld3, meaning it is positioned on the channel 1 (RL1);

furthermore if the memory position is empty it will light on also Ld1, otherwise if it is occupied will light on Ld2.

Now the receiver is positioned on the Code 1.

To select the following Code, press shortly S1. You will ear as many beep as the number of the Code (Code2 =

2 beep, Code3 = 3 beep).

After the 5 Codes related to Channel 1, the device pass to the 5 Codes related to Channel 2 (Ld3 will turn off

and Ld4 turns on).

If you want to store a detector or a remote control on the selected Code Position, press for few seconds S1

until Ld2 will light on (or Ld1 turns off). Now the receiver is waiting for a wireless code; transmit with the sensor

or the remote control to be programmed.. The receiver confimrs the code memorization with the blinking of

Ld3.

Repeat this programming operation for any wireless device to be programmed on the receiver, than open the

jumper JP2 in order to exit from Programming mode.

THE INSTALLER TECHNICIAN MUST FOLLOW THE NORMS OF THE COUNTRY

Channel 1

Relay RL1

This manual can be modified without any advice

Code 1

Channel 2

Code 2

Code 3

Relay RL2

Code 4

Code 5

RX2AP V2.4