Dugena W 615.56-810 Manual de instruções - Página 11

Procurar online ou descarregar pdf Manual de instruções para Ver Dugena W 615.56-810. Dugena W 615.56-810 20 páginas.

Note: Manually activated transmitter call (following section) and automatic recep-

tion (transmitter tower is blinking) will be performed only if no other time zones

were programmed as DCF-time plus/minus one hour. This restriction protects your

battery.

Transmitter call:

Actuate the corrector 2 (right) for more than 3 seconds. The hands of your

watch move fast to 12:00 o'clock position and in normal cases remain exactly in this

position. Should this position not be reached exactly, please continue according to

following instructions "Positioning of the hands" first. In case of immediate exact

position of the hands hold the watch still (best of all take it from the wrist and lay

it on a flat sur face: no metal surface) to establish a secure connection – transmitter

tower is blinking – the LCD seconds display starts counting. After few minutes your

watch sets all current time information automatically and the transmitter call is

finished. To stop the transmitter call before the function is completed, actuate the

button (right) shortly. After that the stored time values will be displayed.

The exact 12:00 o'clock position has not been reached. Actuate the corrector 1

(left) now. The LCD shows "H" (zero position of hour and minute hands). In this

position your watch prompts you to set the hands to the exact 12:00 o'clock posi-

tion through further actuation of the corrector 1 (left). Permanent pressure starts

a continuous fast movement of the hands, single actuation results in individual

steps. As soon as the correct position has been reached, finish the positioning

through a short actuation of the corrector 2 (right).

The LCD shows "S" (zero position of the second-sweep-hand).

In this position your watch prompts you to set the second-sweep-hand to the exact

12:00 o'clock position through further actuation of the corrector 1 (left).

Permanent pressure starts a continuous fast movement of the hands, single actua-

tion results in individual steps. As soon as the correct po sition has been reached,

finish the positioning through a short actuation of the corrector 2 (right).

Switching between the settings of the hours/minutes hands "H" and second-sweep-

hand "S" is possible as many times as you like. As soon as the correct position has

been reached, finish the positioning through actuation of the corrector 2 (right)

for more than 3 seconds. The watch switches to DCF reception mode. Display:

Transmitter tower is blinking.

If you inadvertently actuate both control elements simultaneously for more than 3

seconds, a microprocessor in your watch performs a hardware reset, all saved time

information is lost. In this case follow the instruction for restart of your watch after

replacement of the battery.