Cascade CE2190VC Manual de instruções - Página 3
Procurar online ou descarregar pdf Manual de instruções para Aspirador de pó Cascade CE2190VC. Cascade CE2190VC 5 páginas. Vacuum cleaner
Imprimir páginaBEFORE FIRST USE
•
Your
CASCADE
vacuum
carefully to ensure the product reaches you in good
condition. If the product has been damaged, dropped, has
a malfunction in any way, or if the supply cord is damaged,
immediately contact your retailer for replacement or repair.
•
Carefully unpack your CASCADE vacuum cleaner. Make
sure you do not discard any packaging material until all
parts of the vacuum cleaner have been found.
•
Carefully wipe the exterior of the cleaner to remove any
dust that may have accumulated. Dry with a dry towel. Do
not use harsh abrasive cleaners. Remove any label or
sticker.
WARNING! Do not immerse in water or any other liquids.
OPERATION
•
Carry the vacuum cleaner to the area to be vacuumed.
•
Fit the hose, extending tubes and floor tool to the vacuum
cleaner. Ensure that the vacuum dust bag is correctly
fitted. WARNING! Never use without the dust bag and
main cloth filter fitted. Note. The dust compartment door
will not close without a dust bag correctly fitted.
•
Extend or retract the brush on the main floor tool as
required for the type of floor to be vacuumed. Extend brush
for hard floors such as tiles or wood and retract for rugs
and carpet.
•
Pull out the required amount of power cord from the
vacuum cleaner. WARNING! Do not uncoil past the yellow
marker on the power cord, as this is a warning that the
power cord is close to its full length. If the red indicator on
the power cord is visible, retract back to the yellow
indicator. Damage to the recoiling mechanism can result if
this warning is ignored and will void warranty.
cleaner
has
been
packaged
2
•
Insert the power plug into a mains outlet corresponding
with the vacuum cleaner requirements of 220 – 240V ~ 50
Hz - AC only.
•
Switch on power at the mains outlet.
•
Set the suction control to the desired power level of the
vacuum cleaner.
•
Depress the on/off switch to start or stop the vacuum
cleaner. The cleaner will now start to suction.
•
The vacuum cleaner has a manual air flow regulator
attached to the hose handle. This is used to briefly lower
the suction level during operation; the further open the
regulator the weaker the suction power.
•
Regularly change the dust bag and ensure the main filter is
clean.
When completed disconnect vacuum from the mains supply,
retract cord and empty dust bowl. Store vacuum cleaner along
with all it accessories.
DUST BAG REPLACEMENT
This vacuum cleaner uses model CS003VB dust bag, barcode
number 9421009501106 vacuum dust bag available at The
Warehouse LTD nationwide.
3