Addictive audio B450.1 Manual do proprietário e de instalação - Página 5

Procurar online ou descarregar pdf Manual do proprietário e de instalação para Amplificador Addictive audio B450.1. Addictive audio B450.1 15 páginas.

Imprimir página

other insulation is removed from around the ground area. Use as short of a piece

of cable as possible –

Remote (REM)

Many source units (cd player) or other music sources have an output terminal for

connection of the remote turn-on of the power amplifier. If the source unit doesn't

have a remote turn-on feature, then you can connect the remote wire to a switch

that derives power from an ignition switched circuit.

Power Input Connections

First make +12V wire connection then the ground connection and finally the

remote connection.

battery for protection against possible damage. If you need to replace the power

fuse, replace it with a fuse of the same value. Using a fuse of a different type or

rating may result in a serious hazard.

Fig. 1

Signal Input (RCA)

Addictive Audio amplifiers have RCA connection type input terminal for low level

input. A standard pair of RCA type cables can be used for all models

. The amplifiers allow both stereo and mono input. The amplifier internally will

take a stereo signal and convert to a mono signal. If using the low level output of

one amplifier to provide signal to a stereo amplifier, you must input stereo signal to

the amplifier providing signal to secondary amplifier.

amplifier is made the output to stereo (secondary) amplifier will also be mono.

Adjustment of input level is accomplished by the gain control.

control allows the amplifier gain to be controlled to match the source unit.

Signal Input (High-Level) B450.1

Addictive Audio B450.1 Boost Series amplifier has High-Level inputs as an input

signal option. When High-Level inputs are used the Auto-Start feature can also be

Again, use the same gauge as the +12V.

Caution

Furthermore the +12V wire must always be fused at the

(Refer to Fig. 1)

(Refer to Fig.

If mono input to initial

Adjusting this