Duke TSC-6/18M Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Forno Duke TSC-6/18M. Duke TSC-6/18M 4 páginas.

Main Controller Replacement Instructions:

TSC-6/18 and PBC-6/18

REMOVAL OF OLD CONTROL

1. Verify the Main Control Module Assembly

requires replacement prior to proceeding.

Reference Service Manual Troubleshooting

Guide.

2. Verify recipe settings (recipe names and set

points) with store staff prior to replacement.

Record recipe setting for reference to reprogram

any variance in recipes names and set points on

the new control after replacement.

3. Turn OFF the unit's Power Switch on the left side

middle of the oven.

NOTE: The Main Control Module Assembly

is 12VDC supplied only and is isolated from

dangerous or high voltages by inner safety

cover inside the controls cavity behind the

exterior controls panel.

4. Loosen, but do not remove the bottom and rear

screws on the slide out. Remove top left and top

right screws.

Remove

5. Slide the control panel forward and tilt down the

control panel.

6. Connect ESD Wrist strap to Unit in location

7. Place ESD strap on wrist and tighten. Strap

8. Unplug the two connectors on the back of the

Loosen

shown.

Attach

ESD Strap

to flange

must be tight around wrist to be effective.

Main Control assembly in the unit.