AODELAN WM2 Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Microfone AODELAN WM2. AODELAN WM2 12 páginas.

 If you use a medical electrical device such as a pacemaker, do not attach the transmitter to your

clothes, such as the breast pocket or inner pocket. Using the microphone near a medical device

may adversely affect it.

Pairing the transmitter and receiver

The transmitter(s) and receiver are factory-set to communicate with each other. Therefore, pairing

operation is not necessary, they can be used directly.

If the communication is disconnected or two transmitters are required to communicate with one

receiver simultaneously, please follow the steps below.

1. Turn on the transmitter and receiver.

2. Press and hold the volume buttons "+" and "-" on the receiver for 2 seconds simultaneously,

the receiver enters into the pairing state and the state lamp

per second).



The receiver will automatically exit the pairing state in 10 seconds.

3. While the state lamp on the receiver is blinking quickly, press and hold the "Pair" button on

the transmitter for 2 seconds, the transmitter enters into the pairing state and pairs with the

receiver.



When the transmitter is in the pairing state, its state lamp blinks in blue quickly (twice per

second).

4. When the pairing is complete, the state lamp

state lamp

that the pairing is successful and the communication connection between the transmitter and

the receiver has been established.

Precautions for Use

 If pairing fails, the state lamp blinks once per second. If this happens, redo the procedure from

the beginning.

 One receiver can only communicate with one or two transmitters simultaneously.

Attaching the fur wind screen

Attach the fur wind screen to the transmitter to reduce pop noise caused by breath or strong wind.

1. Place the notched side of the fur wind screen chassis towards the back of the transmitter, and

then attach it down to the top of the transmitter.

2. After attaching, you will hear a click. At this time, the two protrusions on the inner wall of the

chassis of the fur wind screen fit into the jacks on both sides of the transmitter.

on the transmitter blinks in blue slowly (once per 2 seconds); it indicates

blinks in blue quickly (twice

on the receiver stays lit in blue, and the