Danfoss iC7 Series Manual de instalação - Página 11

Procurar online ou descarregar pdf Manual de instalação para Accionamentos DC Danfoss iC7 Series. Danfoss iC7 Series 16 páginas. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Também para Danfoss iC7 Series: Manual de instalação (8 páginas), Manual de instalação (8 páginas), Manual de instalação (6 páginas), Manual de instalação (14 páginas), Manual de instalação (8 páginas), Manual de instalação (8 páginas), Manual de instalação (10 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (6 páginas), Manual de instalação (6 páginas), Manual de instalação (16 páginas), Manual de instalação (18 páginas)

Danfoss iC7 Series Manual de instalação
In-bottom/Out-top Cooling Kit for FA09-FA10
Installation Guide
3.
With the rubber seal in place, carefully slide the inner sleeve of each duct into the outer sleeve.
1
2
3
Illustration 9: Assembly of Telescopic Ducts
1
Inner sleeve of duct
2
Ribbed EPDM rubber seal

2.7 Mounting the Frequency Converter

To install the mounting plate and frequency converter in the Rittal cabinet, use the following steps. Refer to
Procedure
1.
Attach the mounting plate to the cabinet rails, making sure that the pem nuts face the back of the cabinet.
2.
Remove the backing paper from the self adhesive on the cutout gasket.
3.
Affix the gasket over the duct opening in the mounting plate.
4.
Remove the backing paper from the self adhesive on the strip gasket.
5.
Affix the gasket over the lower 2 pem nuts in the mounting plate.
6.
Remove the backing paper from the 2 seal plate gaskets, and affix the gaskets to the seal plates, 1 per plate.
7.
Fasten 2 M10x30 screws through the seal plates, 1 per plate, and into the pem nuts at the lower end of the mounting plate.
Make sure that the screws are secure. The base of the frequency converter rests on the screws.
8.
Slightly lean the top of the frequency converter forward and set the cutouts in the base onto the 2 screws.
9.
Slowly push the top of the frequency converter back against the mounting plate until the top 2 pem nuts line up with the
holes in the frequency converter.
Danfoss A/S © 2022.03
3
Outer sleeve of duct
AN371942791357en-000101 / 136R0254 | 11
Installation
Illustration
10.