Danfoss iC7 Series Manual de instalação - Página 14

Procurar online ou descarregar pdf Manual de instalação para Accionamentos DC Danfoss iC7 Series. Danfoss iC7 Series 18 páginas. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Também para Danfoss iC7 Series: Manual de instalação (8 páginas), Manual de instalação (8 páginas), Manual de instalação (6 páginas), Manual de instalação (14 páginas), Manual de instalação (16 páginas), Manual de instalação (8 páginas), Manual de instalação (8 páginas), Manual de instalação (10 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (6 páginas), Manual de instalação (6 páginas), Manual de instalação (16 páginas)

In-bottom/Out-back Cooling Kit for FA09-FA10

Installation Guide

Remove the paper backing from the duct support plate gasket.

Adhere the gasket to the upper surface of the duct support plate.

Position the duct support plate at the lower end of the frequency converter.

Secure the duct support plate to the frequency converter using 7 M5x16 countersunk screws (T25).

Torque fasteners to 2.3 Nm (20 in-lb).

Illustration 11: Installation of the Duct Support Plate

Frequency converter

Duct support plate gasket

2.9 Assembling the Bottom Duct

The bottom duct is a telescopic duct that collapses to simplify installation. To assemble the duct prior to installation, use the follow-

ing steps. Refer to

Illustration

Procedure

Cut the strip of ribbed EPDM rubber seal into 2 pieces. Use the following measurements:

For FA09 frequency converters, cut 2 strips of 682 mm (26.9 in).

For FA10 frequency converters, cut 2 strips of 877 mm (34.5 in).

Peel the paper off the self-adhesive seals.

Place 1 rubber seal strip on the outside bottom edge of the inner sleeve of the duct, and 1 rubber seal strip on the upper

inside edge of the outer sleeve of the duct.

12.

Duct support plate

M5x16 countersunk screw

AN371942757356en-000101 / 136R0252

Installation