Danfoss VLT AutomationDrive FC 301 Manual de instalação - Página 12

Procurar online ou descarregar pdf Manual de instalação para Accionamentos DC Danfoss VLT AutomationDrive FC 301. Danfoss VLT AutomationDrive FC 301 16 páginas. 24 v dc supply
Também para Danfoss VLT AutomationDrive FC 301: Manual de instalação (20 páginas), Manual de instruções de instalação (6 páginas), Manual de instalação (18 páginas), Manual de instruções de instalação (8 páginas), Manual de instalação (6 páginas), Manual de instalação (16 páginas), Manual de instalação (8 páginas), Manual de instruções de instalação (6 páginas)

Installation

Wiring procedure for enclosure sizes D, E, and F

Mount the fieldbus connector on the fieldbus

option (CAN_L, Drain, CAN_H).

Prepare the fieldbus cable by stripping a section

of the cable insulation. Keep unshielded wire as

short as possible. For cable specifications, refer to

chapter 3.7.1 Cable Specifications.

Connect the fieldbus cable wires to the terminals

according to the colour code of the wires, see

Illustration 3.6.

Fix the cable screen to the metal base plate using

cable clamp or cable tie, see Illustration 3.9.

Tie down the cable and route it with other

control wires inside the unit, see Illustration 3.9.

Illustration 3.9 Wiring for Enclosure Sizes D, E, and F

VLT

CANopen MCA 105

3.8 Reassembling Cover

Follow the instructions in the frequency converter

operating instructions to commission the frequency

converter. The frequency converter automatically detects

the CANopen interface. A new parameter group (Group 10)

appears.

Mount the new front cover and the LCP.

Attach the sticker with the correct product name

to the front cover.

If the address has not been set via the address

switches, go to parameter 10-02 MAC ID to set the

address.

Connect to a running CANopen master.

Check that network cabling is correct or not.

MG33J402